Search results
Results from the WOW.Com Content Network
Normally, the desired outcome of jointing is an edge which is straight along its length and perpendicular to the face of the board. However, there is another technique often used when gluing up panels, referred to as a sprung joint. [1] In this technique, the desired outcome is an edge which is slightly concave along its length.
Router tables are used in one of three ways. In all cases, an accessory is used to direct the workpiece. A fence is used, with the router bit partially emerging from the fence. The workpiece is then moved against the fence, and the exposed portion of the router bit removes material from the workpiece. No fence is used.
On a table saw or router, cutting against the normal feed direction at the end of the cut to prevent tearout. close grain Any wood grain with very fine fibers of cells that are not visibly porous. compass saw conversion The reduction of a whole log into pieces suitable for working. Conversion can be done in three basic ways: sawn, hewn, or ...
A jointer may also be used to flatten the face of a board, in which case the sole focus is to produce a flat surface on the face of the board and the fence is not used. This procedure is often performed prior to edge jointing so that the board has a flat reference face for subsequent operations.
Quarter-sawn boards have greater stability of form and size with less cupping (compared to flatsawn boards), shrinkage across the width, shake and splitting, and other good qualities. [1] In some woods such as oak , the wood grain produces a decorative effect which shows a prominent ray fleck, while sapele is likely to produce a ribbon figure .
There are several types of butt joint based on the orientation of the pieces being joined. These include the T-butt, end-to-end butt, Miter butt and edge-to-edge butt. The T-butt joint is a very simple joint to construct. Members are simply docked (cut off) at a right angle and at the required length.
Solid parquet boards with grooves on the near ends. Tongues on the right sides of the boards and grooves on the left sides. The far ends are tongued. Tongue and groove is a method of fitting similar objects together, edge to edge, used mainly with wood, in flooring, parquetry, panelling, and similar constructions. Tongue and groove joints allow ...
A "D-handle" fixed-base router. The router [a] is a power tool with a flat base and a rotating blade extending past the base. The spindle may be driven by an electric motor or by a pneumatic motor. It routs (hollows out) an area in hard material, such as wood or plastic. Routers are used most often in woodworking, especially cabinetry.