Search results
Results from the WOW.Com Content Network
The stiles and rails often have a profile cut into the inside edge of the outside face - usually a smaller version to match the profile of the panel. In some panel styles, a profile may also be cut on the outside edge of the outside face. [2] In modern cabinetry, the cope and stick joinery is achieved with a set of special router cutters.
Simple split-rail fence Log fence with double posts (photo taken in 1938). A split-rail fence, log fence, or buck-and-rail fence (also historically known as a Virginia, zigzag, worm, snake or snake-rail fence due to its meandering layout) is a type of fence constructed in the United States and Canada, and is made out of timber logs, usually split lengthwise into rails and typically used for ...
Router tables are used in one of three ways. In all cases, an accessory is used to direct the workpiece. A fence is used, with the router bit partially emerging from the fence. The workpiece is then moved against the fence, and the exposed portion of the router bit removes material from the workpiece. No fence is used.
On a table saw or router, cutting against the normal feed direction at the end of the cut to prevent tearout. close grain Any wood grain with very fine fibers of cells that are not visibly porous. compass saw conversion The reduction of a whole log into pieces suitable for working. Conversion can be done in three basic ways: sawn, hewn, or ...
The wagons that ran on these plateway rails had a flat profile. Outram's partner William Jessop preferred the use of "edge rails" where the wheels were flanged and the rail heads were flat - this configuration proved superior to plateways. Jessop's (fishbellied) first edge rails were cast by the Butterley Company. [4]
A "D-handle" fixed-base router. The router [a] is a power tool with a flat base and a rotating blade extending past the base. The spindle may be driven by an electric motor or by a pneumatic motor. It routs (hollows out) an area in hard material, such as wood or plastic. Routers are used most often in woodworking, especially cabinetry.
For fastening flat-bottomed rails, an upper-lipped washer can be used to grip the edge of the rail. They are more resistant to loosening by vibrations and movement of the rail. [ 21 ] They are thought more effective than spikes and screws and so are used in positions such as switch (point) tieplates [ 22 ] and on sharp curves.
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a