Search results
Results from the WOW.Com Content Network
Wi-Fi over Coax is a technology for extending and distributing Wi-Fi signals via coaxial cables.As an in-building wireless solution, Wi-Fi over Coax can make use of existing or new cabling with native impedance of 50 Ω shared by a Wi-Fi access point, cabling run, and antenna.
A CMTS may also act as a bridge or router. A customer's cable modem cannot communicate directly with other modems on the line. In general, cable modem traffic is routed to other cable modems or to the Internet through a series of CMTSs and traditional routers. However, a route could conceivably pass through a single CMTS.
A commercial Wi-Fi antenna, usually a USB Wi-Fi dongle, is suspended in front of the dish, attached by cable to the computer. The WokFi antenna is considered simpler and cheaper than other home-built antenna projects (such as the popular cantenna), but is a very effective method to boost the Wi-Fi connection quality, audit access point coverage ...
In network topology, a cable modem is a network bridge that conforms to IEEE 802.1D for Ethernet networking (with some modifications). The cable modem bridges Ethernet frames between a customer LAN and the coax network. Technically, it is a modem because it must modulate data to transmit it over the cable network, and it must demodulate data ...
The two phrases, "customer-premises equipment" and "customer-provided equipment", reflect the history of this equipment.Under the Bell System monopoly in the United States (post Communications Act of 1934), the Bell System owned the telephones, and one could not attach privately owned or supplied devices to the network, or to the station apparatus.
"Cable router" has two basic meanings: Single Cable Router (SCR) - a down-conversion device for the radio data link. It converts RF signal from a satellite dish or TV antenna to the user-defined IF channel. Usually, many SCRs are connected to a single coaxial cable - each converting to a separate IF channel. The entire system referred to as ...
A cable modem at the customer is connected via coaxial cable to an optical node, and thus into an HFC network. An optical node serves many modems as the modems are connected with coaxial cable to a coaxial cable "trunk" via distribution "taps" on the trunk, which then connects to the node, possibly using amplifiers along the trunk.
The 5.5 GHz cantenna dimensions are almost perfect in that they make a good fit for the standard TV satellite dish. The resulting setup is a low-cost high-quality high-gain antenna. [6] Such setups are widely used in wireless community networks for long-distance Wi-Fi links. Cantennas may be used with other RF devices such as wireless security ...