enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Threaded rod - Wikipedia

   en.wikipedia.org/wiki/Threaded_rod

   Undercut studs are designed to better distribute axial stresses. In a full-bodied stud the stresses are greater in the threads than in the shank. [5] Undercut studs (rolled thread) are also stronger because the metal is "rolled" up to the major diameter, not removed. This preserves the grain of the steel, and in some cases even enhances it ...

3. Stud welding - Wikipedia

   en.wikipedia.org/wiki/Stud_welding

   Capacitor discharge weld studs range from 14 gauge to 3/8" diameter. They come in many different lengths, ranging from 1/4" to 5" and larger. They are usually manufactured from mild or stainless steel, brass, aluminium, and aluminium alloy. The tip on the weld end of the stud serves a twofold purpose:

4. Turnbuckle - Wikipedia

   en.wikipedia.org/wiki/Turnbuckle

   A turnbuckle, stretching screw or bottlescrew is a device for adjusting the tension or length of ropes, cables, tie rods, and other tensioning systems. It normally consists of two threaded eye bolts , one screwed into each end of a small metal frame, one with a conventional right-hand thread and the other with a left-hand thread.

5. ASTM A325 - Wikipedia

   en.wikipedia.org/wiki/ASTM_A325

   ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter.

6. Hardness comparison - Wikipedia

   en.wikipedia.org/wiki/Hardness_comparison

   Hardness Conversion Table – Brinell, Rockwell,Vickers – Various steels . (archived November 11, 2011) Rockwell to Brinell conversion chart (Brinell, Rockwell A,B,C) Struers hardness conversion table (Vickers, Brinell, Rockwell B,C,D)

7. Safety wire - Wikipedia

   en.wikipedia.org/wiki/Safety_wire

   Safety wire is commonly 0.5, 0.6, 0.8 or 1 mm (0.020, 0.025, 0.032 or 0.041 in) in diameter, but 0.5-and-1 mm (0.021-and-0.051 in) diameters are also available. It is usually made of stainless steel, but is also available in monel and inconel alloys for high temperature applications and copper for break-away applications. [7]