Search results
Results from the WOW.Com Content Network
The image of the 7 and 12 pin flat plugs are from the cable entry view (and possibly the images of the round connectors too). Please see reference [2] (VSB1 section 14) for front image. Reference [1] Narva wiring diagrams also have the diagrams cable entry view. If you want the front view images in colour see [3]
The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector. In these cases exclude connection for right tail light (58R) and rear fog light (54G) and connect the tail lights only to pin for left tail light (58L). [11]
If you have a trailer with a lot of lights the diode and relay wiring is preferred, but if you have a trailer with a simple light arrangement it is usually sufficient to wire to 58L. In market there are many special converters [ 1 ] [ 2 ] [ 3 ] that solves the problem of connecting a car with European wiring to a trailer with North American wiring.
Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...
Simple LED (Light Emitting Diode) circuit diagram. In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED.
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
Ground for pin 9 [a] ISO 11446:2004 specifies a 13-pole electrical connector between towing and towed vehicles with 12 volt electrical system . It was developed in 1987 by Erich Jaeger [ 1 ] to replace older 7-pin plugs.
Pin A is for activation of so-called Blackout Mode. It turns off all the lights except convoy lighting if it is active. The lighting inside the vehicle shall also be extinguished if it is not specifically shaded. Pin C is for Convoy Lamps, which is the special convoy lighting, corresponding to the tail lights, to be used while driving in the dark.