Search results
Results from the WOW.Com Content Network
The main advantage of a three-point flexural test is the ease of the specimen preparation and testing. However, this method has also some disadvantages: the results of the testing method are sensitive to specimen and loading geometry and strain rate.
A common label for certifying that a device has been tested. In electrical safety testing, portable appliance testing (PAT inspection or PAT testing) is a process by which electrical appliances are routinely checked for safety, commonly used in the United Kingdom, Ireland, New Zealand and Australia.
IEC 62057-1 Electrical energy meters – Test equipment, techniques and procedures – Part 1: Stationary meter test units (MTUs) IEC 62057-3 Electrical energy meters – Test equipment, techniques and procedures – Part 3: Automatic meter testing system (AMTS) IEC 62058 Electricity metering equipment (AC) – Acceptance inspection
IEC 61000-4-4 is the International Electrotechnical Commission's immunity standard based on electrical fast transient (EFT) / burst transients. This publication is part of the greater IEC 61000 group of standards which is covered under IEC TR 61000-4-1:2016. [ 1 ]
to test rotors in rotating frequency changers, as well as in wound rotors; to test shorts between turns in taped coils before installation into an armature or a stator; as a low voltage isolation transformer; as a high voltage autotransformer bucking or boosting for numerous tests on various types of equipment; for preheating or baking ...
Shear testing is the alternative method to determine the strength a bond can withstand. Various variants of shear testing exist. Like with pull testing, the objective is to recreate the failure mode of interest in the test. If that is not possible, the operator should focus on putting the highest possible load on the bond. [18]
In electrical engineering, electrical safety testing is essential to make sure electrical products and installations are safe. To meet this goal, governments and various technical bodies have developed electrical safety standards. All countries have their own electrical safety standards that must be complied with.
It documents Minimum Energy Performance Requirements for 24 types of residential, commercial, and industrial appliances and equipment in these economies and identifies products with the greatest potential for global harmonization. The study also highlights economy-specific gap analyses, which illustrate gaps in policy coverage and estimate ...