Ads
related to: nightforce 56mm scope ring heightebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Nightforce Optics, Inc. is an American manufacturer of high-end telescopic sights, spotting scopes and mounting accessories, based in Lavonia, Georgia with factory headquarters in Orofino, Idaho. Established in 1992, the company is the optic subsidiary of Lightforce Performance Lighting , an Australian manufacturer of specialty lighting ...
The scope base is the attachment interface on the rifle's receiver, onto which the scope rings or scope mount are fixed. Early telescopic sights almost all have the rings that are fastened directly into tapped screw holes on the receiver, hence having no additional scope base other than the receiver top itself.
The first ACOG model, known as the TA01, was released in 1987. [3] [4] An example was tested on the Stoner 93 in the early 1990s by the Royal Thai Armed Forces. [5]In 1995, United States Special Operations Command selected the 4×32 TA01 as the official scope for the M4 carbine and purchased 12,000 units from Trijicon. [6]
The SPR/A and SPR/B both used the KAC M4 Match FF RAS, KAC part number 99167. Two ARMS #22 Throwlever 30 mm steel rings are used to mount the dayscope. The SPR/A, SPR/B, and Mk 12 MOD 1 use ARMS #22 high rings, while due to the increased height from the SWAN Sleeve, the SPR and Mk 12 MOD 0/H use ARMS #22 medium rings.
Among scopes for rail mounts, the 22.5-degree V-shaped Zeiss rail is the most prevalent standard. It was introduced in 1990. After the patent expired in 2008, compatible scopes have been offered from manufacturers such as Blaser, [1] Leica, Minox, Meopta, Nikon, [2] Noblex (formerly Docter [3]), Schmidt & Bender [4] and Steiner. [5]
A Zeiss rail system typically adds height to the scope body, but also gives the possibility for a slimmer scope mount so that the total scope height can become comparable to a traditional ring mount. The added scope body height due to the rail piece on the scope itself contributes about 5.5 mm (0.22 in) to the total height.
The locking bar system allows for even stress to be distributed and prevent canting of the scope mount. Another form of scope canting is caused by the rings themselves. Many Weaver-type mounts, including many Picatinny-type scope rings and even the Redfield Type, have either two or four screws on top of the scope ring that hold the scope in place.
The ring can be removed and replaced to refresh headspace control on older actions. The AW system cast steel bolt has a 0.75-inch (19.05 mm) diameter combined with gas relief holes in a 0.785 in (19.9 mm) diameter bolt body and front action bridge allowing high-pressure gases a channel of escape in the event of a cartridge-case head failure.
Ads
related to: nightforce 56mm scope ring heightebay.com has been visited by 1M+ users in the past month