Search results
Results from the WOW.Com Content Network
Mortise and tenon joints are strong and stable joints that can be used in many projects. They connect by either gluing or friction-fitting into place. The mortise and tenon joint also gives an attractive look. One drawback to this joint is the difficulty in making it because of the precise measuring and tight cutting required.
Butt joint. A butt joint is a wood joint in which the end of a piece of material is simply placed (or “butted”) against another piece. The butt joint is the simplest joint. An unreinforced butt joint is also the weakest joint, as it provides a limited surface area for gluing and lacks any mechanical interlocking to resist external forces. [1]
A carpenter uses a chain mortiser to cut a large mortise A worker uses a large circular saw to cut joints. Joinery is a part of woodworking that involves joining pieces of wood, engineered lumber, or synthetic substitutes (such as laminate), to produce more complex items. Some woodworking joints employ mechanical fasteners, bindings, or ...
The simple halved joint is created by cutting a slot in opposite edges of the members to be joined so that they slip together. Most commonly, the amount of material removed is equal to half the width of the members being joined, although this depends on the relative dimensions of the members.
Alternatively, the tenon can be rounded with a rasp to achieve an equally strong joint. For cutting small mortises, a normal drill bit can be used. However, for larger mortises, a common type of bit in modern mortisers is a Harry Watt square drill bit, in which a bit with a Reuleaux triangle cross section is allowed to "wobble" while it rotates ...
Corner bridle joint T-bridle joint. A bridle joint is a woodworking joint, similar to a mortise and tenon, in that a tenon is cut on the end of one member and a mortise is cut into the other to accept it. [1] The distinguishing feature is that the tenon and the mortise are cut to the full width of the tenon member.
Although the holes can be plugged the pocket hole may be considered unsightly when all sides of the joint are visible. It is not suitable for joining thin pieces of wood. The boards must have a minimum thickness of 10 to 15 mm (3 ⁄ 8 to 9 ⁄ 16 in). Pocket-hole joints are substantially weaker than joints which use dowels, or mortises. [8]
A Phoenician joint (Latin: coagmenta punicana) is a locked mortise and tenon wood joinery technique used in shipbuilding to fasten watercraft hulls.The locked (or pegged) mortise and tenon technique consists of cutting a mortise, or socket, into the edges of two planks and fastening them together with a rectangular wooden knob.