Search results
Results from the WOW.Com Content Network
A general-purpose input/output (GPIO) is an uncommitted digital signal pin on an integrated circuit or electronic circuit (e.g. MCUs/MPUs) board which may be used as an input or output, or both, and is controllable by software. GPIOs have no predefined purpose and are unused by default.
The term can also be used as part of an action; to "perform I/O" is to perform an input or output operation. I/O devices are the pieces of hardware used by a human (or other system) to communicate with a computer. For instance, a keyboard or computer mouse is an input device for a computer, while monitors and printers are output devices.
The ports are points where input signals are applied or output signals taken. Its behavior is completely specified by a matrix of parameters relating the voltage and current at its ports, so the internal makeup or design of the circuit need not be considered, or even known, in determining the circuit's response to applied signals.
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
It is normal to call a network bridge topology only if it is being used as a two-port network with the input and output ports each consisting of a pair of diagonally opposite nodes. The box topology in figure 1.7 can be seen to be identical to bridge topology but in the case of the filter the input and output ports are each a pair of adjacent ...
Such relationship may take the form of a graph, where numerical values of a circuit variable are plotted versus frequency or component value (the most common example would be a plot of the magnitude of a transfer function vs. frequency). Symbolic circuit analysis is concerned with obtaining those relationships in symbolic form, i.e., in the ...
Z out = the impedance seen looking into the output port when Z s is connected to the input port. Z out is a function of the source impedance. V s = source open circuit or unloaded voltage. V in = voltage applied to the input port by the source. V out = voltage applied to the load by the output port. I in = current entering the input port from ...
Figure 1: Example two-port network with symbol definitions. Notice the port condition is satisfied: the same current flows into each port as leaves that port.. In electronics, a two-port network (a kind of four-terminal network or quadripole) is an electrical network (i.e. a circuit) or device with two pairs of terminals to connect to external circuits.