Ad
related to: cmos cascode amplifier
Search results
Results from the WOW.Com Content Network
The use of a cascode (sometimes verbified to cascoding) is a common technique for improving analog circuit performance, applicable to both vacuum tubes and transistors.The name "cascode" was coined in an article written by Frederick Vinton Hunt and Roger Wayne Hickman in 1939, in a discussion on the application of voltage stabilizers. [3]
CMOS amplifiers (complementary metal ... In telescopic and FC amplifiers, the dominant pole is at the output nodes. Also, there is a non-dominant pole at the cascode ...
This configuration is used less often than the common source or source follower.However, it can be combined with common source amplifiers to create cascode configurations. . It is useful in, for example, CMOS RF receivers, especially when operating near the frequency limitations of the FETs; it is desirable because of the ease of impedance matching and potentially has lower noi
For example, a common base may be used as a current buffer at the output of a common emitter stage, forming a cascode. This will typically reduce the Miller effect and increase the bandwidth of the amplifier. Alternatively, a voltage buffer may be used before the amplifier input, reducing the effective source impedance seen by the input terminals.
A transconductance amplifier (g m amplifier) puts out a current proportional to its input voltage. In network analysis, the transconductance amplifier is defined as a voltage controlled current source (VCCS). These amplifiers are commonly seen installed in a cascode configuration, which improves the frequency response.
The 6N14P (Russian: 6Н14П) is a miniature Russian-made medium gain dual triode vacuum tube, intended for service as a low-noise cascode amplifier at HF through VHF frequencies. It is a direct equivalent of ECC84 and 6CW7 vacuum tubes.
Cascode Voltage Switch Logic (CVSL) refers to a CMOS-type logic family which is designed for certain advantages. It requires mainly N-channel MOSFET transistors to implement the logic using true and complementary input signals, and also needs two P-channel transistors at the top to pull one of the outputs high.
The only terminal remaining is the source. This is a common-source FET circuit. The analogous bipolar junction transistor circuit may be viewed as a transconductance amplifier or as a voltage amplifier. (See classification of amplifiers). As a transconductance amplifier, the input voltage is seen as modulating the current going to the load.
Ad
related to: cmos cascode amplifier