Search results
Results from the WOW.Com Content Network
These can be distinguished as THD F (for "fundamental"), and THD R (for "root mean square"). [12] [13] THD R cannot exceed 100%. At low distortion levels, the difference between the two calculation methods is negligible. For instance, a signal with THD F of 10% has a very similar THD R of 9.95%. However, at higher distortion levels the ...
Spurious-free dynamic range (SFDR) is the strength ratio of the fundamental signal to the strongest spurious signal in the output.It is also defined as a measure used to specify analog-to-digital and digital-to-analog converters (ADCs and DACs, respectively) and radio receivers.
Dynamic range (abbreviated DR, DNR, [1] or DYR [2]) is the ratio between the largest and smallest measurable values of a specific quantity. It is often used in the context of signals, like sound and light.
A signal is applied to the input such that the output increases by 12 dB. The level of the signal needed to produce this is noted. In this case, it was found to be 0.25 microvolts. According to the radio designer, intelligible speech can be detected 12 dB above the receiver's noise floor (noise and distortion).
A ratio higher than 1:1 (greater than 0 dB) indicates more signal than noise. SNR is an important parameter that affects the performance and quality of systems that process or transmit signals, such as communication systems, audio systems, radar systems, imaging systems, and data acquisition systems. A high SNR means that the signal is clear ...
Decibels relative to full scale (dBFS or dB FS) is a unit of measurement for amplitude levels in digital systems, such as pulse-code modulation (PCM), which have a defined maximum peak level. The unit is similar to the units dBov and decibels relative to overload ( dBO ).
Effective number of bits (ENOB) is a measure of the real dynamic range of an analog-to-digital converter (ADC), digital-to-analog converter (DAC), or associated circuitry. . Although the resolution of a converter may be specified by the number of bits used to represent the analog value, real circuits however are imperfect and introduce additional noise and distor
This is the ratio (usually expressed in dB) between the noise floor of the device with no signal and the maximum signal (usually a sine wave) that can be output at a specified (low) distortion level. Since the early 1990s it has been recommended by several authorities including the Audio Engineering Society that measurements of dynamic range be ...