Search results
Results from the WOW.Com Content Network
The enthalpy of vaporization is a function of the pressure and temperature at which the transformation (vaporization or evaporation) takes place. The enthalpy of vaporization is often quoted for the normal boiling temperature of the substance. Although tabulated values are usually corrected to 298 K, that correction is often smaller than the ...
The specific enthalpy of fusion (more commonly known as latent heat) of water is 333.55 kJ/kg at 0 °C: the same amount of energy is required to melt ice as to warm ice from −160 °C up to its melting point or to heat the same amount of water by about 80 °C. Of common substances, only that of ammonia is higher.
The (s) notation indicates equilibrium temperature of vapor over solid. Otherwise temperature is equilibrium of vapor over liquid. log10 of anydrous ammonia vapor pressure. Uses formula shown below. Vapor-pressure formula for ammonia: [4] log 10P = A – B / (T − C), where P is pressure in k Pa, and T is temperature in kelvins;
Up to 99.63 °C (the boiling point of water at 0.1 MPa), at this pressure water exists as a liquid. Above that, it exists as water vapor. Note that the boiling point of 100.0 °C is at a pressure of 0.101325 MPa (1 atm), which is the average atmospheric pressure. Water/steam data table at standard pressure (0.1 M Pa) T °C.
Water vapor, water vapour or aqueous vapor is the gaseous phase of water. It is one state of water within the hydrosphere. Water vapor can be produced from the evaporation or boiling of liquid water or from the sublimation of ice. Water vapor is transparent, like most constituents of the atmosphere. [1] Under typical atmospheric conditions ...
For a liquid–gas transition, is the specific latent heat (or specific enthalpy) of vaporization; for a solid–gas transition, is the specific latent heat of sublimation. If the latent heat is known, then knowledge of one point on the coexistence curve , for instance (1 bar, 373 K) for water, determines the rest of the curve.
ΔHvap is the molar enthalpy of vaporization of the solvent. Through the procedure called ebullioscopy, a known constant can be used to calculate an unknown molar mass. The term ebullioscopy means "boiling measurement" in Latin. This is related to cryoscopy, which determines the same value from the cryoscopic constant (of freezing point ...
Entropy of vaporization. In thermodynamics, the entropy of vaporization is the increase in entropy upon vaporization of a liquid. This is always positive, since the degree of disorder increases in the transition from a liquid in a relatively small volume to a vapor or gas occupying a much larger space. At standard pressure = 1 bar, the ...