enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Light-emitting diode - Wikipedia

   en.wikipedia.org/wiki/Light-emitting_diode

   Typical current ratings range from around 1 mA to above 20 mA. LED's can be soldered to a flexible PCB strip to form LED tape popularly used for decoration. Common package shapes include round, with a domed or flat top, rectangular with a flat top (as used in bar-graph displays), and triangular or square with a flat top.

3. LED circuit - Wikipedia

   en.wikipedia.org/wiki/LED_circuit

   In coin cell powered keyring-type LED lights, the resistance of the cell itself is usually the only current limiting device. LEDs with built-in series resistors are available. These may save printed circuit board space, and are especially useful when building prototypes or populating a PCB in a way other than its designers intended. However ...

4. Chip on board - Wikipedia

   en.wikipedia.org/wiki/Chip_on_board

   The PCB of a quartz watch. The clock IC is under the drop of black epoxy. Chip on board (COB) is a method of circuit board manufacturing in which the integrated circuits (e.g. microprocessors) are attached (wired, bonded directly) to a printed circuit board, and covered by a blob of epoxy. [1]

5. Printed circuit board - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board

   Not to be confused with Printed electronics. For other uses, see PCB (disambiguation). "PC board" redirects here. For the mainboard of personal computers, see Motherboard. "Panelization" redirects here. For the page layout strategy, see N-up. Printed circuit board of a DVD player Part of a 1984 Sinclair ZX Spectrum computer board, a printed circuit board, showing the conductive traces, the ...

6. Via (electronics) - Wikipedia

   en.wikipedia.org/wiki/Via_(electronics)

   Three major kinds of vias are shown in right figure. The basic steps of making a PCB are: making the substrate material and stacking it in layers; through-drilling of plating the vias; and copper trace patterning using photolithography and etching. With this standard procedure, possible via configurations are limited to through-holes.

7. Surface-mount technology - Wikipedia

   en.wikipedia.org/wiki/Surface-mount_technology

   Surface-mount technology (SMT), originally called planar mounting, [1] is a method in which the electrical components are mounted directly onto the surface of a printed circuit board (PCB). [2] An electrical component mounted in this manner is referred to as a surface-mount device (SMD).