Search results
Results from the WOW.Com Content Network
Friis's formula is used to calculate the total noise factor of a cascade of stages, each with its own noise factor and power gain (assuming that the impedances are matched at each stage). The total noise factor can then be used to calculate the total noise figure. The total noise factor is given as
Noise figure (NF) and noise factor (F) are figures of merit that indicate degradation of the signal-to-noise ratio (SNR) that is caused by components in a signal chain.These figures of merit are used to evaluate the performance of an amplifier or a radio receiver, with lower values indicating better performance.
The noise factor (a linear term) is more often expressed as the noise figure (in decibels) using the conversion: = The noise figure can also be seen as the decrease in signal-to-noise ratio (SNR) caused by passing a signal through a system if the original signal had a noise temperature of 290 K. This is a common way of expressing the noise ...
Typical signal quality measures involving noise are signal-to-noise ratio (SNR or S/N), signal-to-quantization noise ratio (SQNR) in analog-to-digital conversion and compression, peak signal-to-noise ratio (PSNR) in image and video coding and noise figure in cascaded amplifiers.
This required difference in power levels of the signal and the noise floor is known as the signal-to-noise ratio (SNR). To establish the minimum detectable signal (MDS) of a receiver we require several factors to be known. Required signal-to-noise ratio (SNR) Detection bandwidth (BW) Temperature T 0 of the receiver system; Receiver noise figure ...
In telecommunications, effective input noise temperature is the source noise temperature in a two-port network or amplifier that will result in the same output noise power, when connected to a noise-free network or amplifier, as that of the actual network or amplifier connected to a noise-free source.
Noise figure measurements can be made with a noise diode, a power supply for the noise diode, and a spectrum analyser. They can also be made with a specialist noise figure meter. The advantage of the noise figure meter is that it will automatically switch the noise diode on and off, giving a continuous reading of Y; it will also have the ...
A noise-figure meter could automate that procedure as follows: A gated broadband noise source (such as an avalanche diode) drives the device under test. A measurement is made with the noise source on; another measurement with the noise source off. From those measurements and the characteristics of the noise source, the noise figure can be ...