Search results
Results from the WOW.Com Content Network
European pipe is standardized to ISO 2531 and its descendent specifications EN 545 (potable water) and EN 598 (sewage). European pipes are sized to approximately match the internal diameter of the pipe, following internal lining, to the nominal diameter. ISO 2531 maintains dimensional compatibility with older German cast iron pipes.
Water fittings and waste fittings for sanitary appliances - Dimensions - Quality: 01.01.1968: Disbanded CEN/TC 35: Building; woodwork, iron-mongery (dimensions, quality) 22.03.1991: Disbanded CEN/TC 36: Valves and taps for water supply in buildings; dimensions; quality: 28.03.1991: Disbanded CEN/TC 37: Building; tile (quality) 22.03.1991 ...
Ductile iron pressure pipes with socket with cement-mortar lining for gas and water pipelines; dimensions and masses: Withdrawn: DIN EN 545, DIN EN 969: EN 545, EN 969: DIN 28610-2: Ductile iron pressure pipes with socket for gas and water pipelines rated for pressures over 4 bar up to and including 16 bar; dimensions and masses: Withdrawn: DIN ...
Cement-mortar lined ductile iron pipe is a ductile iron pipe with cement lining on the inside surface, and is commonly used for water distribution. Cement-mortar lined ductile iron pipe is governed by standards set forth by DIPRA ( Ductile Iron Pipe Research Association ), and was first used in 1922 in Charleston, South Carolina .
For pipe sizes of NPS 14 inch (DN 350) and greater the NPS size is the actual diameter in inches and the DN size is equal to NPS times 25 (not 25.4) rounded to a convenient multiple of 50. For example, NPS 14 has an OD of 14 inches or 355.60 millimetres, and is equivalent to DN 350.
Ductile iron is used in many piano harps (the iron plates which anchor piano strings). Ductile iron is used for vises. Previously, regular cast iron or steel was commonly used. The properties of ductile iron make it a significant upgrade in strength and durability from cast iron without having to use steel, which is expensive and has poor ...
During the IPS period, pipes were cast in halves and welded together, and pipe sizes referred to the inside diameters. [1] The inside diameters under IPS were roughly the same as the more modern Ductile Iron Pipe Standard (DIPS) and Nominal Pipe Size (NPS) Standards, and some of the wall thicknesses were also retained with a different ...
While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...