Search results
Results from the WOW.Com Content Network
Serrated face nut. A serrated face nut is a locknut with ridges on the face of the nut that bite into the surface it is tightened against. The serrations are angled such that they keep the nut from rotating in the direction that would loosen the nut. Due to the serrations they cannot be used with a washer or on surfaces that cannot be scratched ...
Serrated flange nuts. A flange nut is a nut that has a wide flange at one end that acts as an integrated washer.This serves to distribute the pressure of the nut over the part being secured, reducing the chance of damage to the part and making it less likely to loosen as a result of an uneven fastening surface.
The [main] field of the drawing, as opposed to other areas of it, such as the parts list , general notes (G/N), flagnotes , title block , rev block , bill of materials (B/M or BoM or BOM), or list of materials . Rationales for drawing changes that are noted in the rev block often use these abbreviations for brevity (e.g., "DIM 14.00 was 12.50 ...
Keps nut (K-nut or washer nut) with a free-spinning washer. In the locknut form, this is a star-type lock washer. Plate nut; Polymer insert nut ; Security locknut All steel reusable nut for high vibration and harsh environments. Serrated face nut; Serrated flange nut; Speed nut (sheet metal nut or Tinnerman nut) Split beam nut (BINX nut [5])
Prevailing torque type hexagon nuts with flange and with non-metallic insert: Withdrawn: DIN EN 1663, DIN EN 1666: ISO 7043 (modified), ISO 12125 (modified) DIN 6927: Prevailing torque type all-metal nuts with flange: Withdrawn: DIN EN 1664, DIN EN 1667: ISO 7044 (modified), ISO 12126 (modified) DIN 6935: Cold bending of flat rolled steel: Active
The weld access hole or rat hole is a structural engineering technique in which a part of the web of an I-beam or T-beam is cut out at the end or ends of the beam. The hole in the web allows a welder to weld the flange to another part of the structure with a continuous weld the full width on both top and bottom sides of the flange.
A distorted thread locknut, [1] is a type of locknut that uses a deformed section of thread to keep the nut from loosening due to vibrations, or rotation of the clamped item. . There are four types: elliptical offset nuts, centerlock nuts, toplock nuts and partially depitched (Philidas) nu
When the fastener is tightened, the base of the nut, which is arched, elastically deforms and applies a force to the fastener, which locks it from loosening under vibrations. [1] There are many different types of speed nuts, mostly dependent on the shape of the nut, how it attaches to the workpiece, and what type of screw can be used.