enow.com Web Search

  1. Ads

    related to: pipe with 90 degree bend

Search results

  1. Results from the WOW.Com Content Network
  2. Street elbow - Wikipedia

    en.wikipedia.org/wiki/Street_elbow

    Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.

  3. Trap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Trap_(plumbing)

    The U-bend could not jam, so, unlike the S-bend, it did not need an overflow. In the United States, traps are commonly referred to as P-traps. It is the addition of a 90 degree fitting on the outlet side of a U-bend, thereby creating a P-like shape (oriented horizontally). It is also referred to as a sink trap because it is installed under most ...

  4. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    Visualise bending the left end of the pipe up 88 degrees. Now turn the piece of pipe around so the horizontal piece of pipe is in line with the zero degrees line on the protractor. The protractor will read 92 degrees. The key point is that the plumbing term focuses on the degree of bend from the original straight pipe, not the resulting angle.

  5. Miter joint - Wikipedia

    en.wikipedia.org/wiki/Miter_joint

    90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.

  6. JD Squared - Wikipedia

    en.wikipedia.org/wiki/JD_Squared

    In 1983 they designed and released the Model 1 tube bender. The Model 1 Bender became popular because it was one of the few affordable manual tube benders on the fabricating market. However, the Model 1 Bender could only bend 90 degrees. In 1988 JD Squared released the Model 2 Tube bender with 180 degree bend capability.

  7. Bend radius - Wikipedia

    en.wikipedia.org/wiki/Bend_radius

    Bend radius, which is measured to the inside curvature, is the minimum radius one can bend a pipe, tube, sheet, cable or hose without kinking it, damaging it, or shortening its life. The smaller the bend radius, the greater the material flexibility (as the radius of curvature decreases , the curvature increases ).

  1. Ads

    related to: pipe with 90 degree bend