Search results
Results from the WOW.Com Content Network
The lowered pivot point and longer arm length reduce the change in camber and the effect is far less hazardous than powered swing axles for the rear wheels listed above, where the pivot point is approximately on the same side frame rail. [6] The Twin I-Beam suspension includes an additional radius arm link on each side to control caster. [7]
In automobiles, a double wishbone suspension is an independent suspension design using two (occasionally parallel) wishbone-shaped arms to locate the wheel. Each wishbone or arm has two mounting points to the chassis and one joint at the knuckle. The shock absorber and coil spring mount to the wishbones to control vertical movement.
MacPherson strut suspension, track control arm coloured dark blue. In automotive suspension, a control arm, also known as an A-arm, is a hinged suspension link between the chassis and the suspension upright or hub that carries the wheel. In simple terms, it governs a wheel's vertical travel, allowing it to move up or down when driving over ...
The Tilting Suspension System [27] (also known as the Leaning Suspension System) is not a different type or geometry of construction; moreover, it is a technology addition to the conventional suspension system. This kind of suspension system mainly consists of independent suspension (e.g., MacPherson strut, A-arm (double wishbone)). With the ...
With a beam axle, the camber angle between the wheels is the same regardless of its location in the travel of the suspension. A beam axle's location in the fore and aft directions is constrained by one of several suspension components, including trailing arms, semi-trailing arms, radius rods, and leaf springs.
Automotive suspension design is an aspect of automotive engineering, concerned with designing the suspension for cars and trucks. Suspension design for other vehicles is similar, though the process may not be as well established. The process entails Selecting appropriate vehicle level targets; Selecting a system architecture
A short long arms suspension (SLA) is also known as an unequal-length double wishbone suspension. The upper arm is typically an A-arm and is shorter than the lower link, which is an A-arm or an L-arm, or sometimes a pair of tension/compression arms. In the latter case, the suspension can be called a multi-link, or dual-ball joint suspension.
5-link live axle suspension. In automotive suspensions, a suspension link, control link or link is a suspension member, that attaches at only two points. One point being the body or frame of the vehicle and the other point attaching to the knuckle, upright, axle or another link. The link pivots on either a bushing or a ball joint at each ...