Ads
related to: one bushing control arm
Search results
Results from the WOW.Com Content Network
The inboard (chassis) end of a control arm is attached by a single pivot, usually a rubber bushing. It can thus control the position of the outboard end in only a single degree of freedom, maintaining the radial distance from the inboard mount. Although not deliberately free to move, the single bushing does not control the arm from moving back ...
A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing) on one end to the wheel carrier or axle, on the other to the chassis or unibody of the vehicle. Radius rods are ...
Consequently, they react to loads along their own length, in tension and compression, but not in bending. Some multi-links do use a trailing arm, control arm or wishbone, which has two bushings at one end. On a front suspension one of the lateral arms is replaced by the tie-rod, which connects the rack or steering box to the wheel hub.
A bushing is a type of bearing that is used in the suspension system of a vehicle. It is typically used to connect moving parts such as control arms and sway bars to the frame of the vehicle, and also to isolate these parts from each other and from the frame.
One point being the body or frame of the vehicle and the other point attaching to the knuckle, upright, axle or another link. The link pivots on either a bushing or a ball joint at each attachment point. A link differs from a control arm because it can only control one of the degrees of freedom by itself.
Commonly, springs are mounted on control arms, swing arms or some other pivoting suspension member. Consider the example above, where the spring rate was calculated to be 500 lbs/inch (87.5 N/mm), if one were to move the wheel 1 in (2.5 cm) (without moving the car), the spring more than likely compresses a smaller amount.
Ads
related to: one bushing control arm