Search results
Results from the WOW.Com Content Network
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...
Piping or tubing is usually inserted into fittings to make connections. Connectors are assigned a gender, abbreviated M or F. An example of this is a "3 ⁄ 4-inch female adapter NPT", which would have a corresponding male connection of the same size and thread standard (in this case also NPT).
Screw clamps are normally used for hoses 1/2 inch diameter and up, with other clamps used for smaller hoses. The first patent for a worm-drive hose clamp was granted to Swedish inventor Knut Edwin Bergström [ se ] in 1896 [ 1 ] Bergström founded “Allmänna Brandredskapsaffären E. Bergström & Co.” in 1896 (ABA) to manufacture these worm ...
In addition to lengths of pipe or tubing, pipe fittings such as valves, elbows, tees, and unions. are used in plumbing systems. [40] Pipe and fittings are held in place with pipe hangers and strapping. Plumbing fixtures are exchangeable devices that use water and can be connected to a building's plumbing system. They are considered to be ...
These connector's contacts are densely packed with 0.64 mm (0.025 inch) spacing between contact centers in the same row. These connectors are intended for interconnections on printed wiring board (PWB), PWB-to-cable, cable-to-panel, or cable-to-cable on miniaturized equipment sub-assemblies with low power requirements. The connectors are ...
[1] Two banjo fittings (upper center of photo) atop automotive brake calipers. The copper crush washer in the gap between the fitting and body of the caliper completes the seal. Compared to pipe fittings that are themselves threaded, banjo fittings have the advantage that they do not have to be rotated relative to the host fitting. This avoids ...
FMT is a raceway, but not a conduit and is described in a separate NEC Article 360. It only comes in 1/2" & 3/4" trade sizes, whereas FMC is sized 1/2" ~ 4" trade sizes. NEC 360.2 describes it as: "A raceway that is circular in cross section, flexible, metallic and liquidtight without a nonmetallic jacket."
Ducts for air pollution control in a 17000 standard cubic feet per minute regenerative thermal oxidizer (RTO). A round galvanized steel duct connecting to a typical diffuser Fire-resistance rated mechanical shaft with HVAC sheet metal ducting and copper piping, as well as "HOW" (Head-Of-Wall) joint between top of concrete block wall and underside of concrete slab, firestopped with ceramic ...