enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Bipolar junction transistor - Wikipedia

    en.wikipedia.org/wiki/Bipolar_junction_transistor

    The collector–emitter current can be viewed as being controlled by the base–emitter current (current control), or by the base–emitter voltage (voltage control). These views are related by the current–voltage relation of the base–emitter junction, which is the usual exponential current–voltage curve of a p–n junction (diode).

  3. Bipolar transistor biasing - Wikipedia

    en.wikipedia.org/wiki/Bipolar_transistor_biasing

    A load line diagram, illustrating an operating point in the transistor's active region.. Biasing is the setting of the DC operating point of an electronic component. For bipolar junction transistors (BJTs), the operating point is defined as the steady-state DC collector-emitter voltage and the collector current with no input signal applied.

  4. Common emitter - Wikipedia

    en.wikipedia.org/wiki/Common_emitter

    Current gain in the common emitter circuit is obtained from the base and the collector circuit currents. Because a very small change in base current produces a large change in collector current, the current gain (β) is always greater than unity for the common-emitter circuit, a typical value is about 50.

  5. Safe operating area - Wikipedia

    en.wikipedia.org/wiki/Safe_operating_area

    The reverse bias safe operating area (or RBSOA) is the SOA during the brief time before turning the device into the off state—during the short time when the base current bias is reversed. As long as the collector voltage and collector current stay within the RBSOA during the entire turnoff, the transistor will be undamaged.

  6. Common collector - Wikipedia

    en.wikipedia.org/wiki/Common_collector

    Figure 1: Basic NPN common collector circuit (neglecting biasing details).. In electronics, a common collector amplifier (also known as an emitter follower) is one of three basic single-stage bipolar junction transistor (BJT) amplifier topologies, typically used as a voltage buffer.

  7. Hybrid-pi model - Wikipedia

    en.wikipedia.org/wiki/Hybrid-pi_model

    Full hybrid-pi model. The full model introduces the virtual terminal, B′, so that the base spreading resistance, r bb, (the bulk resistance between the base contact and the active region of the base under the emitter) and r b′e (representing the base current required to make up for recombination of minority carriers in the base region) can be represented separately.

  8. Florida bases could receive $488M from defense spending bill

    www.aol.com/news/florida-bases-could-receive-488...

    (The Center Square) – Florida's military bases could receive $488 million from the Department of Defense's fiscal 2025 appropriation if President Joe Biden signs the bill into law. The bill was ...

  9. Early effect - Wikipedia

    en.wikipedia.org/wiki/Early_effect

    Early, is the variation in the effective width of the base in a bipolar junction transistor (BJT) due to a variation in the applied base-to-collector voltage. A greater reverse bias across the collector–base junction, for example, increases the collector–base depletion width, thereby decreasing the width of the charge carrier portion of the ...