enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Socket wrench - Wikipedia

   en.wikipedia.org/wiki/Socket_wrench

   Male bit drivers are sometimes incorrectly referred to as "sockets", but are in fact the opposite of a socket - a socket is a female recess or opening which receives another object. Common male bit drivers of this type include Allen hex wrenches (in both metric and fractional inch sizes), Torx (T-3 through T-50) spline wrenches, 4-point (square ...

3. Screwdriver - Wikipedia

   en.wikipedia.org/wiki/Screwdriver

   A typical simple screwdriver has a handle and a shaft, ending in a tip the user puts into the screw head before turning the handle. This form of the screwdriver has been replaced in many workplaces and homes with a more modern and versatile tool, a power drill, as they are quicker, easier, and can also drill holes.

4. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Standard 12-point hex socket bits and wrenches fit these screws. The screw heads are typically flanged, and may fit into standard Allen hex socket cap screw counterbores molded or machined into parts to be fastened. Compared to Allen hex sockets, the advantages of these bolts include higher torque capability and the lack of a recess to trap water.

5. These Standardized Socket Sets Make Short Work of Auto and ...

   www.aol.com/lifestyle/standardized-socket-sets...

   For premium support please call: 800-290-4726 more ways to reach us

6. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.

7. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Tapered shank tools are removed from a socket using different approaches, depending on the design of the socket. In drill presses and similar tools, the tool is removed by inserting a wedge shaped block of metal called a "drift" into a rectangular shaped cross hole through the socket and tapping it. As the cross section of the drift gets larger ...