Search results
Results from the WOW.Com Content Network
English: Detail of a steel truss, like it is build nowadays, it uses welds and bolds due to the fact it is at site joint, where two parts get connected at site (see Plan of the tuss). It is a part of a Plan (File:Det JoKa008-Model.pdf), which shows three details of a truss (File:Fachwerkplan.pdf)
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
The sub-floor plan provides construction details for this area, including the arrangement of services (such as plumbing and framing structures). Roof plans outline the type of roof and materials to use [4], its pitch and framing structure required. Interior elevation drawings provides detailed views of interior walls that showcase their design ...
The main function of an OWSJ is to provide direct support for roof or floor deck and to transfer the load imposed on the deck to the structural frame i.e. beam and column. In order to accurately design an OWSJ, engineers consider the joist span between bearing points, joist spacing, slope, live loads , dead loads , collateral loads, seismic ...
A truss roof with tongue and groove sheathing. The gap in the sheathing at the ridge is the space designed to allow natural ventilation. Pre-manufactured roof trusses come in a wide variety of styles. They are designed by the manufacturer for each specific building. Timber trusses also are built in a variety of styles using wood or metal joints.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
Shop drawings are produced by contractors and suppliers under their contract with the owner. The shop drawing is the manufacturer’s or the contractor’s drawn version of information shown in the construction documents. [1] The shop drawing normally shows more detail than the construction documents.
In some cases beams are cantilevered out from the concrete column at the center of the building. From the top of the center column, cables are used to support the roof system and the walls. Cables run down from the top of the tower to support floors. The external skeleton of the structure is a type of curtain wall which also is supported by ...