Search results
Results from the WOW.Com Content Network
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
English: a ruler from 0 to 1 inch (in.) in 1/32 inch divisions below the line and 1/2 millimetre (mm) divisions above the line to give a visual representation of the approximations. Principally designed to help visually determine if a metric or imperial drill bit will suffice.
For example, a 1 ⁄ 4-inch to 3 ⁄ 8-inch adapter allows sockets with 1 ⁄ 4-inch drive holes to attach to a 3 ⁄ 8-inch ratchet, and so on. Universal joints are two articulated socket joints (about 1 inch (25 mm) long) combined at a right angle, that allow a bend in the turning axis of the wrench and socket. They are used with extensions ...
In the US, BSW was replaced when steel bolts replaced iron, but was still being used for some aluminium parts as late as the 1960s and 1970s when metric-based standards International Inch replaced the U.S. inch and U.K. inch in 1951-1964. [citation needed] American Unified Coarse (UNC) was originally based on almost the same Imperial fractions ...
Studies show that keeping your head at the appropriate height—about 2 inches (or 5 centimeters) off the bed—helps air flow into the lungs and stabilizes your respiratory function. However ...
View election results from the New Hampshire primaries and see how each candidate performed in townships throughout the state.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.