Search results
Results from the WOW.Com Content Network
Gear oil being added to the final reduction gears in a scooter. EP additives which contain phosphorus/sulfur compounds are corrosive to yellow metals such as the copper and/or brass used in bushings and synchronizers, unless properly buffered; the GL-1 class of gear oils does not contain any EP additives and thus used to be the choice in ...
Spur-gear differential. A spur-gear differential has an equal-sized spur gears at each end, each of which is connected to an output shaft. [8] The input torque (i.e. from the engine or transmission) is applied to the differential via the rotating carrier. [8] Pinion pairs are located within the carrier and rotate freely on pins supported by the ...
While the 9.5-inch rear end exhibits its own durability, it is generally considered less favorable for high-torque applications. The 9.5-inch C-clip rear differential was featured in both the Suburban and pickups, available in 6- or 8-lug variations, employing 33-spline axles. This differential remained in production through 2009 and even found ...
On some differentials only the high speed 2.72–3.73 carrier is used for all gear sets up to 5.89 (JK, Nissan or when thick gears are used) Axle shaft diameter 1.175" front outer (19 spline) 1.20" rear (10 spline) 1.30" rear (19 spline) 1.31" front inner (30 spline) 1.31" rear (30 spline) 1.41" rear (32 spline)
The "S" meaning: single rear axle. The first "1" representing gear reduction type, the second representing the head assembly series and the last "0" representing the design level. The Dana S110 is used in Class 4 and Class 5 applications. Dodge, Ford and General Motors use this axle as well as various other
Ring gear diameter: 9 3 ⁄ 4 " Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1 ...
The rear wheels are located transversely by top links and wheel carriers (green) and lower links (cyan). The top link is the driving half-shaft with a universal joint at each end. The lower link pivots adjacent to the differential casing at its inboard end and where it meets the wheel carrier at the wheel hub casting (violet) at its outboard end.
Spiral bevel gear. A spiral bevel gear is a bevel gear with helical teeth. The main application of this is in a vehicle differential, where the direction of drive from the drive shaft must be turned 90 degrees to drive the wheels. The helical design produces less vibration and noise than conventional straight-cut or spur-cut gear with straight ...