enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Differential (mechanical device) - Wikipedia

   en.wikipedia.org/wiki/Differential_(mechanical...

   Spur-gear differential. A spur-gear differential has an equal-sized spur gears at each end, each of which is connected to an output shaft. [8] The input torque (i.e. from the engine or transmission) is applied to the differential via the rotating carrier. [8] Pinion pairs are located within the carrier and rotate freely on pins supported by the ...

3. Gear oil - Wikipedia

   en.wikipedia.org/wiki/Gear_oil

   Gear oil being added to the final reduction gears in a scooter. EP additives which contain phosphorus/sulfur compounds are corrosive to yellow metals such as the copper and/or brass used in bushings and synchronizers, unless properly buffered; the GL-1 class of gear oils does not contain any EP additives and thus used to be the choice in ...

4. GM 10.5-inch 14-bolt differential - Wikipedia

   en.wikipedia.org/wiki/GM_10.5-inch_14-bolt...

   While the 9.5-inch rear end exhibits its own durability, it is generally considered less favorable for high-torque applications. The 9.5-inch C-clip rear differential was featured in both the Suburban and pickups, available in 6- or 8-lug variations, employing 33-spline axles. This differential remained in production through 2009 and even found ...

5. Dana 44 - Wikipedia

   en.wikipedia.org/wiki/Dana_44

   On some differentials only the high speed 2.72–3.73 carrier is used for all gear sets up to 5.89 (JK, Nissan or when thick gears are used) Axle shaft diameter 1.175" front outer (19 spline) 1.20" rear (10 spline) 1.30" rear (19 spline) 1.31" front inner (30 spline) 1.31" rear (30 spline) 1.41" rear (32 spline)

6. Dana S 110 - Wikipedia

   en.wikipedia.org/wiki/Dana_S_110

   The "S" meaning: single rear axle. The first "1" representing gear reduction type, the second representing the head assembly series and the last "0" representing the design level. The Dana S110 is used in Class 4 and Class 5 applications. Dodge, Ford and General Motors use this axle as well as various other

7. Spiral bevel gear - Wikipedia

   en.wikipedia.org/wiki/Spiral_bevel_gear

   Spiral bevel gear. A spiral bevel gear is a bevel gear with helical teeth. The main application of this is in a vehicle differential, where the direction of drive from the drive shaft must be turned 90 degrees to drive the wheels. The helical design produces less vibration and noise than conventional straight-cut or spur-cut gear with straight ...

8. Overdrive (mechanics) - Wikipedia

   en.wikipedia.org/wiki/Overdrive_(mechanics)

   This is especially important because the differential gears are bathed in heavy oil and seldom provided with any cooling besides air blowing over the housing. The impetus is to minimize overdrive use and provide a higher ratio first gear, which means more gears between the first and the last to keep the engine at its most efficient speed.

9. Transaxle - Wikipedia

   en.wikipedia.org/wiki/Transaxle

   Csonka transaxle from 1908 Drawing of the "Alfa Transaxle" layout, with gearbox mounted in block at the rear differential; also inboard brakes to reduce unsprung mass. A transaxle is a single mechanical device which combines the functions of an automobile's transmission, axle, and differential into one integrated assembly. [1]