Search results
Results from the WOW.Com Content Network
The Princeton circuits up through 5C2 differed from the Fender Champ in having two versus one preamp stage (6SC7 dual-triode vs 6SJ7 pentode) and added the tone control that was absent in the Champs; the 12AX7-based Princeton models 5D2 through 5F2-A were essentially the Champ circuits 5D1 through 5F1 with a tone control and a somewhat larger ...
Bank of two-motion switches. The Strowger switch is the first commercially successful electromechanical stepping switch telephone exchange system. It was developed by the Strowger Automatic Telephone Exchange Company founded in 1891 by Almon Brown Strowger. Because of its operational characteristics, it is also known as a step-by-step (SXS) switch.
Figure 1: Example two-port network with symbol definitions. Notice the port condition is satisfied: the same current flows into each port as leaves that port.. In electronics, a two-port network (a kind of four-terminal network or quadripole) is an electrical network (i.e. a circuit) or device with two pairs of terminals to connect to external circuits.
3.2 Gen 1x2, USB 3.2 Gen 2x1, USB4 Gen 2×1) 10 Gbit/s: 1.212 GB/s: 2013 External PCI Express 2.0 ×4: 16 Gbit/s: 2 GB/s: Thunderbolt: 2 × 10 Gbit/s: 2 × 1.25 GB/s: 2011 USB 3.2 SuperSpeed+ (aka USB 3.2 Gen 2×2 USB4 Gen 2×2, USB4 Gen 3×1) [45] 20 Gbit/s: 2.424 GB/s: 2017 Thunderbolt 2: 20 Gbit/s: 2.5 GB/s: 2013 FPGA Mezzanine Card Plus ...
A von Neumann architecture scheme. The von Neumann architecture—also known as the von Neumann model or Princeton architecture—is a computer architecture based on the First Draft of a Report on the EDVAC, [1] written by John von Neumann in 1945, describing designs discussed with John Mauchly and J. Presper Eckert at the University of Pennsylvania's Moore School of Electrical Engineering.
In electrical engineering, a stepping switch or stepping relay, also known as a uniselector, is an electromechanical device that switches an input signal path to one of several possible output paths, directed by a train of electrical pulses. The major use of stepping switches was in early automatic telephone exchanges to route telephone calls ...
The input is left side, the output with load is right side. The switch is typically a MOSFET, IGBT, or BJT transistor. A buck converter or step-down converter is a DC-to-DC converter which decreases voltage, while increasing current, from its input to its output . It is a class of switched-mode power supply.
The utilization of the binary properties of electrical switches to perform logic functions is the basic concept that underlies all electronic digital computer designs. Shannon's thesis became the foundation of practical digital circuit design when it became widely known among the electrical engineering community during and after World War II.