Search results
Results from the WOW.Com Content Network
Failed aluminium electrolytic capacitors with open vents in the top of the can, and visible dried electrolyte residue (reddish-brown color) The capacitor plague was a problem related to a higher-than-expected failure rate of non-solid aluminium electrolytic capacitors between 1999 and 2007, especially those from some Taiwanese manufacturers, [1] [2] due to faulty electrolyte composition that ...
Phrases used by the tech savvy to mean that a problem is caused entirely by the fault of the user include PEBKAC [8] (an acronym for "problem exists between keyboard and chair"), PEBCAK [9] (an alternative, but similar, acronym for "problem exists between chair and keyboard"), POBCAK (a US government/military acronym for "problem occurs between ...
A stuck sub-pixel or stuck pixel is a pixel that is always "on". [2] This is usually caused by a transistor that is getting power all the time (VA/IPS) or not getting any power (TN) and is therefore continuously allowing light at that point to pass through to the RGB layer. Any given pixel will stay red, blue, or green and will not change when ...
Tantalum capacitors in different styles: axial, radial and SMD-chip versions (size comparison with a match) 10 μF 30 VDC-rated tantalum capacitors, solid electrolyte epoxy-dipped style. A tantalum electrolytic capacitor is an electrolytic capacitor , a passive component of electronic circuits .
This page contains a dump analysis for errors #64 (Link equal to linktext).. It can be generated using WPCleaner by any user. It's possible to update this page by following the procedure below:
1) Values for a typical capacitor with 100 μF/10–16 V Aluminum electrolytic capacitors with non-solid electrolyte are the best known and most widely used electrolytic capacitors. These components can be found on almost all boards of electronic equipment. They are characterized by particularly inexpensive and easy to process base materials.
From 1999 through at least 2010, a stolen recipe for such a water-based electrolyte, in which important stabilizers [47] [48] were absent, [49] led to the widespread problem of "bad caps" (failing electrolytic capacitors), leaking or occasionally bursting in computers, power supplies, and other electronic equipment, which became known as the ...
Capacitors used for suppressing undesirable frequencies are sometimes called filter capacitors. They are common in electrical and electronic equipment, and cover a number of applications, such as: Glitch removal on direct current (DC) power rails; Radio frequency interference (RFI) removal for signal or power lines entering or leaving equipment