Search results
Results from the WOW.Com Content Network
This frequency, divided by 2 16 (the largest divisor the 8253 is capable of) produces the ≈18.2 Hz timer interrupt used in MS-DOS and related operating systems. In the original IBM PCs, Counter 0 is used to generate a timekeeping interrupt. Counter 1 is used to trigger the refresh of DRAM memory. Counter 2 is used to generate tones via the PC ...
The Intel 8253 PIT was the original timing device used on IBM PC compatibles.It used a 1.193182 MHz clock signal (one third of the color burst frequency used by NTSC, one twelfth of the system clock crystal oscillator, [1] therefore one quarter of the 4.77 MHz CPU clock) and contains three timers.
The first-generation Intel APIC chip, the 82489DX, which was meant to be used with Intel 80486 and early Pentium processors, is actually an external local and I/O APIC in one circuit. The Intel MP 1.4 specification refers to it as "discrete APIC" in contrast with the "integrated APIC" found in most of the Pentium processors. [ 2 ]
For a list of current programs, see List of Mac software. Third-party databases include VersionTracker , MacUpdate and iUseThis . Since a list like this might grow too big and become unmanageable, this list is confined to those programs for which a Wikipedia article exists.
The references to two timers is not true. In Intel ICH4 documentation, the timer exists in IO ports 40h..43h, and the same timer is aliased to IO ports 50h..53h for some reason. A very good guess would be that the original IBM PC had it like this too to simplify IO address decoding, but this is just a guess.
Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts.
A tickless kernel is an operating system kernel in which timer interrupts do not occur at regular intervals, but are only delivered as required. [1]The Linux kernel on s390 from 2.6.6 [2] and on i386 from release 2.6.21 [3] can be configured to turn the timer tick off (tickless or dynamic tick) for idle CPUs using CONFIG_NO_HZ, and from 3.10 with CONFIG_NO_HZ_IDLE extended for non-idle ...
On March 6, 2000, AMD demonstrated passing the 1 GHz milestone a few days ahead of Intel shipping 1 GHz in systems. In 2002, an Intel Pentium 4 model was introduced as the first CPU with a clock rate of 3 GHz (three billion cycles per second corresponding to ~ 0.33 nanoseconds per cycle). Since then, the clock rate of production processors has ...