Search results
Results from the WOW.Com Content Network
10 Gigabit Ethernet (abbreviated 10GE, 10GbE, or 10 GigE) is a group of computer networking technologies for transmitting Ethernet frames at a rate of 10 gigabits per second. It was first defined by the IEEE 802.3ae-2002 standard.
The Category 7 cable standard was ratified in 2002, and primarily introduced to support 10 gigabit Ethernet over 100 m of copper cabling. [2] It contains four twisted copper wire pairs, just like the earlier standards, terminated either with GG45 electrical connectors or with TERA connectors rated for transmission frequencies of up to 600 MHz. [3]
10 Gigabit Ethernet is a version of Ethernet with a nominal data rate of 10 Gbit/s, ten times as fast as Gigabit Ethernet. The first 10 Gigabit Ethernet standard, IEEE Std 802.3ae-2002, was published in 2002. Subsequent standards encompass media types for single-mode fiber (long haul), multi-mode fiber (up to 400 m), copper backplane (up to 1 m ...
When used for 10/100/1000BASE-T, the maximum allowed length of a Cat 6 cable is 100 meters (328 ft). This consists of 90 meters (295 ft) permanent link, which is typically solid horizontal cabling between two connectors, often the patch panel and the wall jack, plus 10 meters (33 ft) total of stranded patch cordage. [14]
Gigabit Ethernet: 96 ns: 64 ns (64 bit times) 2.5 Gigabit Ethernet: 38.4 ns: 16 ns (40 bit times) 5 Gigabit Ethernet: 19.2 ns: 8 ns (40 bit times) 10 Gigabit Ethernet: 9.6 ns: 4 ns (40 bit times) 25 Gigabit Ethernet: 3.84 ns: 1.6 ns (40 bit times) 40 Gigabit Ethernet: 2.4 ns: 200 ps (8 bit times) 50 Gigabit Ethernet: 1.92 ns: 160 ps (8 bit ...
1000BASE-LX is an optical fiber Gigabit Ethernet standard specified in IEEE 802.3 Clause 38 which uses a long wavelength laser (1,270–1,355 nm), and a maximum RMS spectral width of 4 nm. 1000BASE-LX is specified to work over a distance of up to 5 km over 10 μm single-mode fiber.
The 10 Gbit/s Ethernet Passive Optical Network standard, better known as 10G-EPON allows computer network connections over telecommunication provider infrastructure. The standard supports two configurations: symmetric, operating at 10 Gbit/s data rate in both directions, and asymmetric, operating at 10 Gbit/s in the downstream (provider to customer) direction and 1 Gbit/s in the upstream ...
A standardized variant of 10 Gigabit Ethernet, called WAN PHY, is designed to inter-operate with OC-192 transport equipment while the common version of 10 Gigabit Ethernet is called LAN PHY (which is not compatible with OC-192 transport equipment in its native form). The naming is somewhat misleading, because both variants can be used on a wide ...