enow.com Web Search

  1. Ads

    related to: 1964 corvette traction unit wiring kit

Search results

  1. Results from the WOW.Com Content Network
  2. Traction control system - Wikipedia

    en.wikipedia.org/wiki/Traction_control_system

    The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.

  3. Chevrolet Corvette (C2) - Wikipedia

    en.wikipedia.org/wiki/Chevrolet_Corvette_(C2)

    The 1959 Corvette Sting Ray concept and 1960 XP-700 show car in the front and the 1963 Corvette convertible and fastback in the back. The 1963 Sting Ray production car's lineage can be traced to two separate GM projects: the Q-Corvette, and Bill Mitchell's racing Sting Ray.

  4. Chevrolet Turbo-Air 6 engine - Wikipedia

    en.wikipedia.org/wiki/Chevrolet_Turbo-Air_6_engine

    Hadley Engineering — Developed a kit sold under the name "Trans-Vair". This product included a full sub-frame that allowed a complete Corvair powertrain to be installed in a modified Volkswagen chassis. [115] Lukes and Shorman — One of the first companies to offer a kit to adapt the Turbo-Air 6 to a Volkswagen transaxle. [116]

  5. General Motors XP-819 - Wikipedia

    en.wikipedia.org/wiki/General_Motors_XP-819

    Chevrolet Corvette: The XP-819 was a one-off concept car, developed by General Motors in 1965, to test a rear engine configuration for the Chevrolet Corvette. Design

  6. Napco Four Wheel Drive Vehicles - Wikipedia

    en.wikipedia.org/wiki/Napco_Four_Wheel_Drive...

    Just as easily, the kit could be removed and re-used on another truck, and this was used as a selling point. The retail price of NAPCO Powr-Pak kit in 1955 was $995. Many companies would install them, the price rising from $1250 to $1550 with labor, bringing the total price for a new GM pickup from $1,548.96 for 2WD to as low as $2,796.96 for 4WD.

  7. Chevrolet Corvette (C3) - Wikipedia

    en.wikipedia.org/wiki/Chevrolet_Corvette_(C3)

    The Corvette C3 was patterned after the Mako Shark II designed by Larry Shinoda. Executed under Bill Mitchell's direction, the Mako II had been initiated in early 1964. Once the mid-engined format was abandoned, the Shinoda/Mitchell car was sent to Chevrolet Styling under David Holls, where Harry Haga's studio adapted it for production on the ...

  1. Ads

    related to: 1964 corvette traction unit wiring kit