Search results
Results from the WOW.Com Content Network
The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
Metric (SI) units. 25.4 mm. A fire hydrant marked as 3-inch. The inch (symbol: in or ″) is a unit of length in the British Imperial and the United States customary systems of measurement. It is equal to 1 36 yard or 1 12 of a foot. Derived from the Roman uncia ("twelfth"), the word inch is also sometimes used to translate ...
A 12-gauge shotgun, nominally 18.5 mm (0.73 in), can range from a tight 18 mm (0.71 in) to an extreme overbore of 20 mm (0.79 in). Some also claim an increased velocity with the overbored barrels, up to 15 m/s (49 ft/s), which is due to the larger swept volume of the overbored barrel.
A 3.5 mm headphone connector. Display sizes for screens on TVs and computer monitors are advertised and sold in inches (measured diagonally), although most boxes also state the size in centimeters. The original 1 ⁄ 4 inch (6.35 mm) phone connector jack dates back to 1878 [53] [54] [55] and still sees use in audio equipment and electric ...
A circular mil is a unit of area, equal to the area of a circle with a diameter of one mil (one thousandth of an inch or 0.0254 mm). It corresponds to approximately 5.067 × 10−4 mm2. It is a unit intended for referring to the area of a wire with a circular cross section. As the definition of the unit contains π, it is easy to calculate area ...
Thickness of aluminum foil is measured in mils (1 ⁄ 1000 inch, or 0.0254 mm) in the United States. Cross-sectional area of electrical wire is measured in circular mils in the U.S. and Canada, one circular mil (cmil) being equal to 5.067 × 10 −4 mm 2 (or 7.854 × 10 −7 in 2). Since this is so small, actual wire is commonly measured in ...
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
If using the metric unit meters for distance and the imperial unit inches for target size, one has to multiply by a factor of 25.4, since one inch is defined as 25.4 millimeters. distance in meters = target in inches angle in mrad × 25.4 {\displaystyle {\text{distance in meters}}={\frac {\text{target in inches}}{\text{angle in mrad}}}\times 25.4}