Search results
Results from the WOW.Com Content Network
A 12-gauge shotgun, nominally 18.5 mm (0.73 in), can range from a tight 18 mm (0.71 in) to an extreme overbore of 20 mm (0.79 in). Some also claim an increased velocity with the overbored barrels, up to 15 m/s (49 ft/s), which is due to the larger swept volume of the overbored barrel.
The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
All 20 mm cartridges have an outside projectile diameter and barrel bore diameter of approximately 0.787 inches (20.0 mm). These projectiles are typically 75 to 127 mm (3–5 in) long, cartridge cases are typically 75 to 152 mm (3–6 in) long, and most are shells , with an explosive payload and detonating fuze .
Original nominal 25 mm figure scale; though a 6-foot human in 1:87 is closer to 21 mm. 1:82: 3.717 mm An intermediate scale (HO/OO) intended to apply to both HO and OO scale train sets. Also used for some military models 1:80: 3.810 mm HOj scale. Very close to wargaming 20 mm figure scale (20 mm is actually 1:80.5). [10] 1:76.2: 4 mm: Model ...
medium-bore refers to calibers with a diameter of 0.33 inches (8.4 mm) to 0.39 inches (9.9 mm) large-bore refers to calibers with a diameter of 0.40 inches (10 mm) or larger There is much variance in the use of the term "small-bore", which over the years has changed considerably, with anything under 0.577 inches (14.7 mm) considered "small-bore ...
In the United States, Canada, and Mexico, ring sizes are specified using a numerical scale with 1⁄4 steps, where whole sizes differ by 0.032 inches (0.81 mm) of internal diameter, equivalent to 0.1005 inches (2.55 mm) of internal circumference. The relationship of this size ( ) to ISO 8653:2016 circumference ( ) is , while the relationship to ...
Thickness of aluminum foil is measured in mils (1 ⁄ 1000 inch, or 0.0254 mm) in the United States. Cross-sectional area of electrical wire is measured in circular mils in the U.S. and Canada, one circular mil (cmil) being equal to 5.067 × 10 −4 mm 2 (or 7.854 × 10 −7 in 2). Since this is so small, actual wire is commonly measured in ...
For instance the same angle of 0.1 mrad will subtend 10 mm at 100 meters, 20 mm at 200 meters, etc., or similarly 0.39 inches at 100 m, 0.78 inches at 200 m, etc. Subtensions in mrad based optics are particularly useful together with target sizes and shooting distances in metric units. The most common scope adjustment increment in mrad based ...