Search results
Results from the WOW.Com Content Network
DIN 5466-1: Splined joints, calculation of load capacity – Part 1: general basis: Active: DIN 5473: Logic and set theory; symbols and concepts: Active: DIN 5474: Signs in mathematical logic: Withdrawn: DIN 5473: DIN 5475-1: Complex quantities; nomenclature: Withdrawn: DIN 5483-3: DIN 5480-1: Involute splines based on reference diameters ...
A spline is a ridge or tooth [1] [2] [3] on a drive shaft that matches with a groove in a mating piece and transfers torque to it, maintaining the angular correspondence between them. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear.
Hirth joint made from anodized aluminum to show the meshing of the teeth Hirth joint (disassembled) between the semi-axles of a Campagnolo Ultra-Torque crankset. Face spline joints consist of a ring of radial splines or teeth milled or ground into the end faces of two rotary components such as a drive shaft and the hub of a wheel.
Shaft angle. A shaft angle is the angle between the axes of two non-parallel gear shafts. In a pair of crossed helical gears, the shaft angle lies between the oppositely rotating portions of two shafts. This applies also in the case of worm gearing. In bevel gears, the shaft angle is the sum of the two
Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1.625" Pinion shaft splines: 10 or 29
The benefit is the larger ring gear, better angle cut on the teeth and Dana 60 diameter pinion shaft. The Dana Spicer Max momentary output torque FT-lbs Low pinion Dana 44 30 spline.....3460 [ft-lbs] High pinion Dana 44 30 spline.....4170 [ft-lbs] Low pinion rear 8.9" Dana 44 32 spline..5340 [ft-lbs]
Get breaking news and the latest headlines on business, entertainment, politics, world news, tech, sports, videos and much more from AOL
35 Spline axle shafts with a 1.5 in (38 mm) diameter; Ratios 3.08 to 4.30. Current production ratios offered are 3.31, 3.55, 3.73, and 4.30. Since ca. 2005, the gears are formed by the face hob process, formerly face milled process.