enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.

3. Nail (fastener) - Wikipedia

   en.wikipedia.org/wiki/Nail_(fastener)

   Most countries, except the United States, use a metric system for describing nail sizes. A 50 × 3.0 indicates a nail 50 mm long (not including the head) and 3 mm in diameter. Lengths are rounded to the nearest millimetre. For example, finishing nail* sizes typically available from German suppliers are:

4. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A center punch is used to mark the center of a point. It is usually used to mark the center of a hole when drilling holes. A drill has the tendency to "wander" if it does not start in a recess. A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1]

5. Pilot hole - Wikipedia

   en.wikipedia.org/wiki/Pilot_hole

   For standard wood screws, special pilot drill bits are manufactured to produce the correct hole profile in a single operation, rather than needing several different drill bit sizes and depths. [3] Screws driven into concrete must have the appropriate size pilot hole, or they will either break on insertion, strip the hole, or not provide the ...

6. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.

7. Robertson screw - Wikipedia

   en.wikipedia.org/wiki/Robertson_screw

   Robertson screwdrivers are easy to use one-handed, because the tapered socket tends to retain the screw, even if it is shaken. [3]: 85–86 They also allow the use of angled screwdrivers and trim-head screws. The socket-headed Robertson screws are self-centering and reduce cam out. They also stop a power tool when set, and can be more easily ...