enow.com Web Search

  1. Ad

    related to: dimmable light switch wiring

Search results

  1. Results from the WOW.Com Content Network
  2. Light switch - Wikipedia

    en.wikipedia.org/wiki/Light_switch

    The toggle light switch was invented in 1916 by William J. Newton. [2] As a component of an electrical wiring or home wiring system, the installation of light switches is regulated by some authority concerned with safety and standards. In different countries the standard dimensions of the wall mounting hardware (boxes, plates, etc.) may differ.

  3. Dimmer - Wikipedia

    en.wikipedia.org/wiki/Dimmer

    Non domestic dimmers are usually controlled remotely by means of various protocols. Analogue dimmers usually require a separate wire for each channel of dimming carrying a voltage between 0 and 10 V. Some analogue circuitry then derives a control signal from this and the mains supply for the switches.

  4. Multiway switching - Wikipedia

    en.wikipedia.org/wiki/Multiway_switching

    In building wiring, multiway switching is the interconnection of two or more electrical switches to control an electrical load from more than one location.A common application is in lighting, where it allows the control of lamps from multiple locations, for example in a hallway, stairwell, or large room.

  5. DMX512 - Wikipedia

    en.wikipedia.org/wiki/DMX512

    Typically a dimmer has a starting address that represents the lowest-numbered dimmer in that pack, and the addressing increases from there to the highest-numbered dimmer. As an example, for two packs of six dimmers each, the first pack would start at address 1 and the second pack at address 7. Each slot in the DMX512 packet corresponds to one ...

  6. C-Bus (protocol) - Wikipedia

    en.wikipedia.org/wiki/C-Bus_(protocol)

    The power control in a C-Bus system lies in a “Dimmer” or “Relay” which is installed in the DB and replaces the traditional switch used in conventional wiring. This Dimmer (or Relay) has a 120/230 V Line interconnection directly to the ceiling light and a neutral connection back from the ceiling light to the Dimmer.

  7. Wireless light switch - Wikipedia

    en.wikipedia.org/wiki/Wireless_light_switch

    Dimmer light switch with RF-based remote control [1] A wireless light switch is a light switch that commands a light or home appliance to turn itself off or on, instead of interrupting the power line going to the light fixture. There are different ways to communicate between the switch and the fixture: [2]

  8. 0-10 V lighting control - Wikipedia

    en.wikipedia.org/wiki/0-10_V_lighting_control

    Dimming fluorescent ballasts and dimming LED drivers often use 0–10 V control signals to control dimming functions. In many cases, the dimming range of the power supply or ballast is limited. If the light output can only be dimmed from 100% down to 10%, there must be a switch or relay available to kill power to the system and turn the light ...

  9. 3-way lamp - Wikipedia

    en.wikipedia.org/wiki/3-way_lamp

    A 3-way lamp, also known as a tri-light, is a lamp that uses a 3-way light bulb to produce three levels of light in a low-medium-high configuration. A 3-way lamp requires a 3-way bulb and socket, and a 3-way switch. In 3-way incandescent light bulbs, each of the filaments operates at full voltage. Lamp bulbs with dual carbon filaments were ...

  1. Ad

    related to: dimmable light switch wiring