Search results
Results from the WOW.Com Content Network
HDPE pipe is a type of flexible plastic pipe used to transfer fluids and gases. It is often employed for replacing aging concrete or steel main pipelines . Constructed from the thermoplastic HDPE (high-density polyethylene ), it has low permeability and robust molecular bonding, making it suitable for high-pressure pipelines .
The bodies of fittings for pipe and tubing are often the same base material as the pipe or tubing connected: copper, steel, PVC, CPVC, or ABS. Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the ...
HDPE is known for its high strength-to-density ratio. [4] The density of HDPE ranges from 930 to 970 kg/m 3. [5] Although the density of HDPE is only marginally higher than that of low-density polyethylene, HDPE has little branching, giving it stronger intermolecular forces and tensile strength (38 MPa versus 21 MPa) than LDPE. [6]
Plastic Pipe lengths manufactured in Australia by extruding HDPE material.. Plastic pipe is a tubular section, or hollow cylinder, made of plastic.It is usually, but not necessarily, of circular cross-section, used mainly to convey substances which can flow—liquids and gases (fluids), slurries, powders and masses of small solids.
JM Eagle is an American corporation and a manufacturer of plastic pipe. [1] At its 22 plants in North America, the company manufactures polyvinyl chloride (PVC) and high-density polyethylene pipe for a variety of industries including utility, plumbing, electrical, natural gas, irrigation, potable water, drainage, and sewage.
Pipe Wall Thickness: Each thickness to be fused in production (XXVI–2310(c)). (6) Fitting Manufacturer: A change in fitting manufacturer. (7) Pipe Diameter: Each diameter to be fused in production (XXVI–2310(c)). (8) Cool-down Time: A decrease in the cool time at pressure from that qualified. (9) Fusion Voltage: A change in fusion voltage. (10)
Adaptor plates that match the outside diameter of the main pipe are applied to the heating plate to perform this type of fusion. [8] Another method used is referred to as electrofusion. Electrofusion is a method of joining HDPE and other plastic pipes with special fittings that have built-in resistive wire which is used to weld the joint ...
A common post-extrusion process for plastic sheet stock is thermoforming, where the sheet is heated until soft (plastic), and formed via a mold into a new shape. When vacuum is used, this is often described as vacuum forming. Orientation (i.e. ability/ available density of the sheet to be drawn to the mold which can vary in depths from 1 to 36 ...