Ad
related to: proper lock washer placement
Search results
Results from the WOW.Com Content Network
This type of washer is especially effective as a lock washer when used with a soft substrate, such as aluminium or plastic, [8] and can resist rotation more than a plain washer on hard surfaces, as the tension between washer and the surface is applied over a much smaller area (the teeth). There are four types: internal, external, combination ...
Isometric projection of a grub screw with a hex socket head.. Set screws are not always the best way to resist the torque of driven shafts. To reduce the chance of slipping and to increase load capacity, a detent (often called a "flat") may be milled or ground at the part of the shaft where the set screw's point contacts.
Locking washers, size M4. A lock ring is a threaded washer used to prevent components from becoming loose during rotation. [1] They are found on an adjustable bottom bracket and a track hub of a bicycle. Lokring is another form of fastener used in the automotive and air condition industries: these fittings are often confused with lockrings.
Standard nut employed as a jam nut against another standard nut. A jam nut is a low profile type of nut, typically half as tall as a standard nut.It is commonly used as a type of locknut, where it is "jammed" up against a standard nut to lock the two in place.
A positive locking device is a device used in conjunction with a fastener in order to positively lock the fastener. This means that the fastener cannot work loose from vibrations. The following is a list of positive locking devices: [1] A split beam nut; A castellated nut and a split pin; A hex nut or cap screw and a tab washer
The simplest – and strongest – form of anchor bolt is cast-in-place, with its embedded end consisting of a standard hexagonal head bolt and washer, 90-bend, or some sort of forged or welded flange (see also stud welding). The last are used in concrete-steel composite structures as shear connectors. [6]
A safety wire is used to ensure proper security for a fastener. The wire needed is long enough to reach from a fixed location to a hole in the removable fastener, such as a pin — a clevis fastener, sometimes a linchpin or hitch-pin through a clevis yoke for instance — and the wire pulled back upon itself, parallel to its other end, then twisted, a single end inserted through a fastener ...
A Keps nut, (also called a k-lock nut [1] or washer nut), is a nut with an attached, free-spinning washer. It is used to make assembly more convenient. Common washer types are star-type lock washers, conical, and flat washers.
Ad
related to: proper lock washer placement