Search results
Results from the WOW.Com Content Network
Symbolic circuit analysis is a formal technique of circuit analysis to calculate the behaviour or characteristic of an electric/electronic circuit with the independent variables (time or frequency), the dependent variables (voltages and currents), and (some or all of) the circuit elements represented by symbols. [1] [2]
The SI unit of impedance is the ohm with the symbol of the upper case Greek letter omega (Ω) and the SI unit for admittance is the siemens with the symbol of an upper case letter S. Normalised impedance and normalised admittance are dimensionless. Actual impedances and admittances must be normalised before using them on a Smith chart.
Many equivalent series resistance (ESR) meters, essentially AC milliohm-meters normally used to measure the ESR of capacitors, can be used to estimate battery internal resistance, particularly to check the state of discharge of a battery rather than obtain an accurate DC value. [2] Some chargers for rechargeable batteries indicate the ESR.
In electrical engineering, impedance is the opposition to alternating current presented by the combined effect of resistance and reactance in a circuit. [1]Quantitatively, the impedance of a two-terminal circuit element is the ratio of the complex representation of the sinusoidal voltage between its terminals, to the complex representation of the current flowing through it. [2]
Voltage generators are modelled as an ideal voltage source in series with a resistor. Current generators are modelled as an ideal current source in parallel with a resistor. The resistor is referred to as the internal resistance of the source. Real world equipment may not perfectly follow these models, especially at extremes of loading (both ...
The current through an ideal voltage source is completely determined by the external circuit. When connected to an open circuit, there is zero current and thus zero power. When connected to a load resistance, the current through the source approaches infinity as the load resistance approaches zero (a short circuit). Thus, an ideal voltage ...
[2]: 2-8 - 2-9 For all nodes, except a chosen reference node, the node voltage is defined as the voltage drop from the node to the reference node. Therefore, there are N-1 node voltages for a circuit with N nodes. [2]: 2-10 In principle, nodal analysis uses Kirchhoff's current law (KCL) at N-1 nodes to get N-1 independent equations. Since ...
Simplified model for powering a load with resistance R L by a source with voltage V S and resistance R S.. The theorem was originally misunderstood (notably by Joule [4]) to imply that a system consisting of an electric motor driven by a battery could not be more than 50% efficient, since the power dissipated as heat in the battery would always be equal to the power delivered to the motor when ...