enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Subnet - Wikipedia

    en.wikipedia.org/wiki/Subnet

    For IPv4, a network may also be characterized by its subnet mask or netmask, which is the bitmask that, when applied by a bitwise AND operation to any IP address in the network, yields the routing prefix. Subnet masks are also expressed in dot-decimal notation like an IP address. For example, the prefix 198.51.100.0 / 24 would have the subnet ...

  3. Link-local address - Wikipedia

    en.wikipedia.org/wiki/Link-local_address

    Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.

  4. IP address - Wikipedia

    en.wikipedia.org/wiki/IP_address

    The term subnet mask is only used within IPv4. Both IP versions however use the CIDR concept and notation. In this, the IP address is followed by a slash and the number (in decimal) of bits used for the network part, also called the routing prefix. For example, an IPv4 address and its subnet mask may be 192.0.2.1 and 255.255.255.0, respectively.

  5. Classless Inter-Domain Routing - Wikipedia

    en.wikipedia.org/wiki/Classless_Inter-Domain_Routing

    A subnet mask is a bitmask that encodes the prefix length associated with an IPv4 address or network in quad-dotted notation: 32 bits, starting with a number of 1-bits equal to the prefix length, ending with 0-bits, and encoded in four-part dotted-decimal format: 255.255.255.0. A subnet mask encodes the same information as a prefix length but ...

  6. Routing table - Wikipedia

    en.wikipedia.org/wiki/Routing_table

    The network address and subnet mask of the interface, along with the interface type and number, are entered into the routing table as a directly connected network. A remote network is a network that can only be reached by sending the packet to another router. Routing table entries to remote networks may be either dynamic or static.

  7. route (command) - Wikipedia

    en.wikipedia.org/wiki/Route_(command)

    Destination: Network destination of the route; mask Netmask: The netmask (subnet mask) associated with the network destination; Gateway: The forwarding or next hop IP address over which the set of addresses defined by the network destination and subnet mask are reachable; metric Metric: Integer cost metric (ranging from 1 to 9999) for the route

  8. Gateway address - Wikipedia

    en.wikipedia.org/wiki/Gateway_address

    When packets are sent over a network, the destination IP address is examined. If the destination IP is outside of the network, then the packet goes to the gateway for transmission outside of the network. The gateway is on the same network as end devices. The gateway address must have the same subnet mask as host devices. Each host on the ...

  9. IPv4 - Wikipedia

    en.wikipedia.org/wiki/IPv4

    For example, the loopback address 127.0.0.1 was commonly written as 127.1, given that it belongs to a class-A network with eight bits for the network mask and 24 bits for the host number. When fewer than four numbers were specified in the address in dotted notation, the last value was treated as an integer of as many bytes as are required to ...