Search results
Results from the WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
This increase in 2016 is even more marked when looking at the number of products recalled (as opposed to recall event) due to foreign body contamination. In 2016 there were 422 products recalled due to foreign body contamination, whilst in 2015 there were 108; almost a 300% increase.
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.
Manifold vacuum, or engine vacuum in a petrol engine is the difference in air pressure between the engine's intake manifold and Earth's atmosphere.. Manifold vacuum is an effect of a piston's movement on the induction stroke and the airflow through a throttle in the intervening carburetor or throttle body leading to the intake manifold.
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
1995 Cadillac Seville disengaged emissions controls whenever heat or air conditioning was on. In 1995, General Motors was ordered to recall 470,000 model year 1991 through 1995 Cadillacs and pay an $11 million fine for programming the car's electronic control unit (ECU) to enrich the fuel mixture any time the car's air conditioning or cabin heat was operating, since the EPA tests are conducted ...
The system uses tubes with poppet valves from a central injector to spray fuel at each intake port rather than the central throttle body [citation needed]. Fuel pressure is similar to a single-point injection system. CPFI (used from 1992 to 1995) is a batch-fire system, while CSFI (from 1996) is a sequential system. [9]
Wide open throttle or wide-open throttle (WOT), also called full throttle, is the fully opened state of a throttle on an engine (internal combustion engine or steam engine). The term also, by extension, usually refers to the maximum-speed state of running the engine, as the normal result of a fully opened throttle plate/ butterfly valve .