Search results
Results from the WOW.Com Content Network
is the voltage at maximum load. The maximum load is the one that draws the greatest current, i.e. the lowest specified load resistance (never short circuit); is the voltage at minimum load. The minimum load is the one that draws the least current, i.e. the highest specified load resistance (possibly open circuit for some types of linear ...
A low line regulation is always preferred. In practice, a well regulated power supply should have a line regulation of at most 0.1%. [1] In the regulator device datasheets the line regulation is expressed as percent change in output with respect to change in input per volt of the output. Mathematically it is expressed as:
Output power factor remains in the range of 0.96 or higher from half to full load. Because it regenerates an output voltage waveform, output distortion, which is typically less than 4%, is independent of any input voltage distortion, including notching. Efficiency at full load is typically in the range of 89% to 93%.
If energy output and input are expressed in the same units, efficiency is a dimensionless number. [1] Where it is not customary or convenient to represent input and output energy in the same units, efficiency-like quantities have units associated with them. For example, the heat rate of a fossil fuel power plant may be expressed in BTU per ...
The theoretical-maximum efficacy lowers for wavelengths at either side of 555 nm. For example, low-pressure sodium lamps produce monochromatic light at 589 nm with a luminous efficacy of 200 lm/w, which is the highest of any lamp. The theoretical-maximum efficacy at that wavelength is 525 lm/w, so the lamp has a luminous efficiency of 38.1%.
The output impedance is a measure of the source's propensity to drop in voltage when the load draws current, the source network being the portion of the network that transmits and the load network being the portion of the network that consumes. Because of this the output impedance is sometimes referred to as the source impedance or internal ...
1. These are commonly found in myths, legends and stories. 2. These are used to sort/organize digital messages. 3. Fizzy beverages with a sharp, zesty taste. 4. The words in this category sound ...
Therefore, the efficiency of all real machines is less than 1. A hypothetical machine without friction is called an ideal machine; such a machine would not have any energy losses, so its output power would equal its input power, and its efficiency would be 1 (100%). For hydropower turbines the efficiency is referred to as hydraulic efficiency ...