Search results
Results from the WOW.Com Content Network
The first routine measurements of river flow in England began on the Thames and Lea in the 1880s, [2] and in Scotland on the River Garry in 1913. [3] The national gauging station network was established in its current form by the early 1970s and consists of approximately 1500 flow measurement stations supplemented by a variable number of temporary monitoring sites. [2]
A discharge is a measure of the quantity of any fluid flow over unit time. The quantity may be either volume or mass. Thus the water discharge of a tap (faucet) can be measured with a measuring jug and a stopwatch. Here the discharge might be 1 litre per 15 seconds, equivalent to 67 ml/second or 4 litres/minute. This is an average measure.
In hydrology, a rating curve is a graph of discharge versus stage for a given point on a stream, usually at gauging stations, where the stream discharge is measured across the stream channel with a flow meter. [1] Numerous measurements of stream discharge are made over a range of stream stages.
Measure a length of stream, and mark the start and finish points. The longest length without changing stream conditions is desired to obtain the most accurate measurement. Place an orange at the starting point and measure the time for it to reach the finish point with a stopwatch. Repeat this at least three times and average the measurement times.
A stream hydrograph is commonly determining the influence of different hydrologic processes on discharge from the subject catchment. Because the timing, magnitude, and duration of groundwater return flow differs so greatly from that of direct runoff, separating and understanding the influence of these distinct processes is key to analyzing and simulating the likely hydrologic effects of ...
The Embudo Stream Gauging Station is a stream gauge established in 1888 as the United States Geologic Survey's first training center for hydrographers. The station, near the town of Embudo along the Rio Grande in northern New Mexico , was used to develop tools and techniques for measuring stream flow in the arid, western United States.
In a nozzle or other constriction, the discharge coefficient (also known as coefficient of discharge or efflux coefficient) is the ratio of the actual discharge to the ideal discharge, [1] i.e., the ratio of the mass flow rate at the discharge end of the nozzle to that of an ideal nozzle which expands an identical working fluid from the same initial conditions to the same exit pressures.
It is described by the fact that the discharge through a river of an approximate rectangular cross-section must, through conservation of mass, equal Q = u ¯ b h {\displaystyle Q={\bar {u}}bh} where Q {\displaystyle Q} is the volumetric discharge, u ¯ {\displaystyle {\bar {u}}} is the mean flow velocity, b {\displaystyle b} is the channel ...