Search results
Results from the WOW.Com Content Network
File size is a measure of how much data a computer file contains or how much storage space it is allocated. Typically, file size is expressed in units based on byte. A large value is often expressed with a metric prefix (as in megabyte and gigabyte) or a binary prefix (as in mebibyte and gibibyte). [1]
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
For Blu-ray discs, 1× speed is defined as 36 megabits per second (Mbit/s), which is equal to 4.5 megabytes per second (MB/s). [7] However, as the minimum required data transfer rate for Blu-ray movie discs is 54 Mbit/s, the minimum speed for a Blu-ray drive intended for commercial movie playback should be 2×. The fastest Blu-ray speed is 16×.
4 kB: About one page of text from a novel; 120 kB: The text of a typical pocket book; 1 MiB: A 1024×1024 pixel bitmap image with 256 colors (8 bpp color depth) 3 MB: A three-minute song (133 kbit/s) 650–900 MB – a CD-ROM; 1 GB: 114 minutes of uncompressed CD-quality audio at 1.4 Mbit/s; 16 GB: DDR5 DRAM laptop memory under $40 (as of early ...
10,000 read IOPS, 36,000 write IOPS at QD1 550 MB/s sequential read, 520 MB/s sequential write on 256 GB and larger models 550 MB/s sequential read, 470 MB/s sequential write on 128 GB model [18] Virident Systems tachIOn SSD Up to [neutrality is disputed] 320,000 sustained READ IOPS using 4 kB blocks, and up to 200,000 sustained WRITE IOPS ...
Additional time required to move to the first track of the next cylinder and begin reading; the name cylinder is used because typically all the tracks of a drive with more than one head or data surface are read before moving the actuator. This time is typically about twice the track-to-track seek time. As of 2001, it was about 2 to 3 ms. [31]
Hard disk drives store data in the magnetic polarization of small patches of the surface coating on a disk. The maximum areal density is defined by the size of the magnetic particles in the surface, as well as the size of the "head" used to read and write the data. In 1956 the first hard drive, the IBM 350, had an areal density of 2,000 bit/in 2.
While the gross data rate equals 33.3 million 4-bit-transfers per second (or 16.67 MB/s), the fastest transfer, firmware read, results in 15.63 MB/s. The next fastest bus cycle, 32-bit ISA-style DMA write, yields only 6.67 MB/s .