enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Ballistic coefficient - Wikipedia

    en.wikipedia.org/wiki/Ballistic_coefficient

    The formula for calculating the ballistic coefficient for small and large arms projectiles only is as follows: = [2] where: C b,projectile, ballistic coefficient as used in point mass trajectory from the Siacci method (less than 20 degrees).

  3. External ballistics - Wikipedia

    en.wikipedia.org/wiki/External_ballistics

    This schlieren image of a bullet travelling in free-flight demonstrates the air-pressure dynamics surrounding the bullet. External ballistics or exterior ballistics is the part of ballistics that deals with the behavior of a projectile in flight. The projectile may be powered or un-powered, guided or unguided, spin or fin stabilized, flying ...

  4. Projectile motion - Wikipedia

    en.wikipedia.org/wiki/Projectile_motion

    Lofted trajectories of North Korean ballistic missiles Hwasong-14, Hwasong-15 and Hwasong-17. A special case of a ballistic trajectory for a rocket is a lofted trajectory, a trajectory with an apogee greater than the minimum-energy trajectory to the same range. In other words, the rocket travels higher and by doing so it uses more energy to get ...

  5. Miller twist rule - Wikipedia

    en.wikipedia.org/wiki/Miller_twist_rule

    Miller twist rule is a mathematical formula derived by American physical chemist and historian of science Donald G. Miller (1927-2012) to determine the rate of twist to apply to a given bullet to provide optimum stability using a rifled barrel. [1]

  6. Taylor knock-out factor - Wikipedia

    en.wikipedia.org/wiki/Taylor_knock-out_factor

    The Taylor KO factor multiplies bullet mass (measured in grains) by muzzle velocity (measured in feet per second) by bullet diameter (measured in inches) and then divides the product by 7,000, converting the value from grains to pounds and giving a numerical value from 0 to ~150 for normal hunting cartridges.

  7. Sectional density - Wikipedia

    en.wikipedia.org/wiki/Sectional_density

    As an example, a bullet with a mass of 160 grains (10.4 g) and a diameter of 0.264 in (6.7 mm), has a sectional density (SD) of: 4·(160 gr/7000) / (π·0.264 in 2 ) = 0.418 lb m /in 2 As another example, the M107 projectile mentioned above with a mass of 95.2 pounds (43.2 kg) and having a body diameter of 6.0909 inches (154.71 mm) has a ...

  8. Rifleman's rule - Wikipedia

    en.wikipedia.org/wiki/Rifleman's_rule

    One can calculate using standard Newtonian dynamics as follows (for more details on this topic, see Trajectory). Two equations can be set up that describe the bullet's flight in a vacuum, (presented for computational simplicity compared to solving equations describing trajectories in an atmosphere).

  9. Ballistic table - Wikipedia

    en.wikipedia.org/wiki/Ballistic_table

    Example of a ballistic table for a given 7.62×51mm NATO load. Bullet drop and wind drift are shown both in mrad and MOA.. A ballistic table or ballistic chart, also known as the data of previous engagements (DOPE) chart, is a reference data chart used in long-range shooting to predict the trajectory of a projectile and compensate for physical effects of gravity and wind drift, in order to ...