enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hydraulic cylinder - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_cylinder

   A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.

3. Load cell - Wikipedia

   en.wikipedia.org/wiki/Load_cell

   This pressure is then transmitted to a hydraulic pressure gauge via a high pressure hose. [4] The gauge's Bourdon tube senses the pressure and registers it on the dial. Because this sensor has no electrical components, it is ideal for use in hazardous areas. [5] Typical hydraulic load cell applications include tank, bin, and hopper weighing. [6]

4. Pressure measurement - Wikipedia

   en.wikipedia.org/wiki/Pressure_measurement

   Example of the widely used Bourdon pressure gauge Checking tire pressure with a spring and piston tire-pressure gauge. Pressure measurement is the measurement of an applied force by a fluid (liquid or gas) on a surface. Pressure is typically measured in units of force per unit of surface area.

5. Deadweight tester - Wikipedia

   en.wikipedia.org/wiki/Deadweight_tester

   A dead weight tester (DWT) is a calibration standard method that uses a piston cylinder on which a load is placed to make an equilibrium with an applied pressure underneath the piston. Deadweight testers are secondary standards which means that the pressure measured by a deadweight tester is defined through other quantities: length, mass and time.

6. Fluid power - Wikipedia

   en.wikipedia.org/wiki/Fluid_power

   A fluid power system has a pump driven by a prime mover (such as an electric motor or internal combustion engine) that converts mechanical energy into fluid energy, Pressurized fluid is controlled and directed by valves into an actuator device such as a hydraulic cylinder or pneumatic cylinder, to provide linear motion, or a hydraulic motor or pneumatic motor, to provide rotary motion or torque.

7. Hydrostatic test - Wikipedia

   en.wikipedia.org/wiki/Hydrostatic_test

   For example, if a cylinder was rated to DOT-2015 PSI (approximately 139 bar), it would be tested at around 3360 PSI (approximately 232 bar). Water is commonly used because it is cheap and easily available, and is usually harmless to the system to be tested. Hydraulic fluids and oils may be specified where contamination with water could cause ...