enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Power good signal - Wikipedia

   en.wikipedia.org/wiki/Power_good_signal

   The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.

3. Power supply unit (computer) - Wikipedia

   en.wikipedia.org/wiki/Power_supply_unit_(computer)

   While an ATX power supply is connected to the mains supply, it always provides a 5-volt standby (5VSB) power so that the standby functions on the computer and certain peripherals are powered. ATX power supplies are turned on and off by a signal from the motherboard. They also provide a signal to the motherboard to indicate when the DC voltages ...

4. PS-ON Signal - Wikipedia

   en.wikipedia.org/wiki/PS-ON_Signal

   #PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).

5. Power-on self-test - Wikipedia

   en.wikipedia.org/wiki/Power-on_self-test

   A power-on self-test (POST) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on. [ 1 ] POST processes may set the initial state of the device from firmware and detect if any hardware components are non-functional.

6. ATX - Wikipedia

   en.wikipedia.org/wiki/ATX

   An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...

7. Iddq testing - Wikipedia

   en.wikipedia.org/wiki/Iddq_testing

   Also, increasing circuit size means a single fault will have a lower percentage effect, making it harder for the test to detect. However, Iddq is so useful that designers are taking steps to keep it working. One particular technique that helps is power gating, where the entire power supply to each block can be switched off using a low leakage ...

8. Four-terminal sensing - Wikipedia

   en.wikipedia.org/wiki/Four-terminal_sensing

   Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...

9. 80 Plus - Wikipedia

   en.wikipedia.org/wiki/80_Plus

   For a given power supply, efficiency varies depending on how much power is being delivered. Supplies are typically most efficient at between half and three-quarters load, much less efficient at low load, and somewhat less efficient at maximum load. Older ATX power supplies were typically 60% to 75% efficient. To qualify for 80 Plus, a power ...