Search results
Results from the WOW.Com Content Network
DIN 332-2: Center holes 60° with thread for shaft ends for rotating electrical machines: Active: DIN 332-4: Centre holes for rail vehicles axles: Active: DIN 332-7: Machine tools; 60° centre holes; dimensioning: Active: DIN 332-8: Centre holes 90°, form S; dimensions, determination process: Active: DIN 332-10: Center Holes; Indications on ...
E DIN # is a draft standard and DIN V # is a preliminary standard. DIN EN # is used for the German edition of European standards. DIN ISO # is used for the German edition of ISO standards. DIN EN ISO # is used if the standard has also been adopted as a European standard., Some of the DIN standards date back to the time of Nazi Germany.
This page was last edited on 4 September 2013, at 01:10 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
A drafting table Old-fashioned technical drawing instruments Stencils for lettering technical drawings to DIN standards. The basic drafting procedure is to place a piece of paper (or other material) on a smooth surface with right-angle corners and straight sides—typically a drawing board.
The German Commission for Electrotechnical, Electronic & Information Technologies of DIN and VDE (German: Deutsche Kommission Elektrotechnik Elektronik Informationstechnik im DIN und VDE), abbreviated DKE, is the German organisation responsible for the development and adoption of standards and safety specifications in the areas of electrical engineering, electronics and information technologies.
3×32 DIN 41612 female connectors can be seen on the green motherboard in back. A NuBus motherboard, with six female 3×32 DIN 41612 connectors (black, centre left). DIN 41612 was a DIN standard for electrical connectors that are widely used in rack based electrical systems. Standardisation of the connectors is a pre-requisite for open systems ...
Publicly Available Standards, with free access to a small subset of the standards. Advanced search for standards and/or projects Online Browsing Platform (OBP) , access to most up to date content in ISO standards, graphical symbols, codes or terms and definitions.
DIN 7876 may be applied to all full-foot and open-heel fin models made from either rubber or plastic, but the standard excludes long-bladed fins for competitive use. In the interests of health and safety, this standard stipulates that no protruding edges should be in evidence at any point of contact between the fins and the feet.