enow.com Web Search

  1. Ads

    related to: what is an attenuator for coaxial cable tv transmitter input switch

Search results

  1. Results from the WOW.Com Content Network
  2. Attenuator (electronics) - Wikipedia

    en.wikipedia.org/wiki/Attenuator_(electronics)

    An attenuator is a passive broadband electronic device that reduces the power of a signal without appreciably distorting its waveform. An attenuator is effectively the opposite of an amplifier, though the two work by different methods. While an amplifier provides gain, an attenuator provides loss, or gain less than unity. An attenuator is often ...

  3. Optical attenuator - Wikipedia

    en.wikipedia.org/wiki/Optical_attenuator

    Built-in variable optical attenuators may be either manually or electrically controlled. A manual device is useful for one-time set up of a system, and is a near-equivalent to a fixed attenuator, and may be referred to as an "adjustable attenuator". In contrast, an electrically controlled attenuator can provide adaptive power optimization.

  4. Diplexer - Wikipedia

    en.wikipedia.org/wiki/Diplexer

    Older TV installations may use a solid dielectric RG-59 cable, and that cable may be inadequate. [1] RG-6 cable is typically used for satellite feed lines. In this application, there would be a diplexer on the roof that joins the satellite dish feed and the TV antenna together into a single coaxial cable.

  5. Attenuation - Wikipedia

    en.wikipedia.org/wiki/Attenuation

    There also exist optical attenuators that decrease the signal in a fiber optic cable intentionally. Attenuation of light is also important in physical oceanography . This same effect is an important consideration in weather radar , as raindrops absorb a part of the emitted beam that is more or less significant, depending on the wavelength used.

  6. Klystron - Wikipedia

    en.wikipedia.org/wiki/Klystron

    An electronic oscillator can be made from a klystron tube, by providing a feedback path from output to input by connecting the "catcher" and "buncher" cavities with a coaxial cable or waveguide. When the device is turned on, electronic noise in the cavity is amplified by the tube and fed back from the output catcher to the buncher cavity to be ...

  7. Television interference - Wikipedia

    en.wikipedia.org/wiki/Television_interference

    It is possible to also get a bad picture if the signal strength of the TV transmitter is too high. An attenuator inserted in the antenna lead-in wire may be used if the television receiver displays signs of overload in the RF front end. Strong out-of-band signals may also affect television reception and may require band-pass filters to reduce ...

  8. Low-noise block downconverter - Wikipedia

    en.wikipedia.org/wiki/Low-noise_block_downconverter

    This downconversion allows the signal to be carried to the indoor satellite TV receiver using relatively cheap coaxial cable; if the signal remained at its original microwave frequency it would require an expensive and impractical waveguide line.

  9. Balun - Wikipedia

    en.wikipedia.org/wiki/Balun

    If a coil is made using coaxial cable near to the feed point of a balanced antenna, then the RF current that flows on the outer surface of the coaxial cable can be attenuated. One way of doing this would be to pass the cable through a ferrite toroid. The end result is exactly the same as a 1:1 current balun (or Guanella-type balun).

  1. Ads

    related to: what is an attenuator for coaxial cable tv transmitter input switch