enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Tow hitch - Wikipedia

   en.wikipedia.org/wiki/Tow_hitch

   The trailer hitch ball attaches to a ball mount; with a diameter typically 1 ⁄ 16 inch (1.6 mm) larger than the ball bolt/shank diameter. [2] The ball mount must match the SAE hitch class. [3] The ballmount for a receiver-type hitch is a square bar that fits into a receiver attached to the vehicle.

3. Fifth-wheel coupling - Wikipedia

   en.wikipedia.org/wiki/Fifth-wheel_coupling

   The coupling consists of a kingpin, a 2-or-3 + 1 ⁄ 2-inch-diameter (50.8 or 88.9 mm) vertical steel pin protruding from the bottom of the front of the semi-trailer, and a horseshoe-shaped coupling device called a fifth wheel on the rear of the towing vehicle. As the connected truck turns, the downward-facing surface of the semi-trailer (with ...

4. Taper pin - Wikipedia

   en.wikipedia.org/wiki/Taper_pin

   A 1:50 taper means that one end of a 50 mm long bar will be 1 mm smaller in diameter than the other end. Inch-sized taper pins have a slightly smaller taper taper on diameter of 1:48 [2] A 1:48 taper means that one end of a 4-foot-long bar (48 inches) will be 1 inch smaller in diameter than the other end, or a 1 ⁄ 4-inch taper over a 1-foot ...

5. R-clip - Wikipedia

   en.wikipedia.org/wiki/R-clip

   D: Cross-section of a new split pin An R-clip , also known as an R-pin , R-key , hairpin cotter pin , [ 1 ] hairpin cotter , [ 2 ] bridge pin , [ 2 ] hitch pin clip [ 3 ] [ 4 ] or spring cotter pin , [ 5 ] is a fastener made of a durable but flexible material, commonly hardened metal wire, resembling the shape of the letter "R".

6. ISO standards for trailer connectors - Wikipedia

   en.wikipedia.org/wiki/ISO_standards_for_trailer...

   7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.

7. Clevis fastener - Wikipedia

   en.wikipedia.org/wiki/Clevis_fastener

   Threaded clevis pins have a partially threaded shank on one end and a formed head on the other. The formed head has a lip, which acts as a stop when threading the pin into the shackle, and a flattened tab with a cross-hole. The flattened tab allows for easy installation of the pin and the cross-hole allows the pin to be moused. [3]